TPM-2XLEDEQ-4X3-CPR
120W LED Pole Light
(2) LED Lamps - 3' to 8.5' Adjustable - 9-64V DC
Instruction Manual
IMPORTANT
READ CAREFULLY BEFORE INSTALLING THIS FIXTURE. SAVE THESE INSTRUCTIONS FOR FUTURE
REFERENCE. THE
TPM-2XLEDEQ-4X3-CPR
MUST BE WIRED IN ACCORDANCE WITH NATIONAL ELECTRICAL
CODE AND ALL APPLICABLE LOCAL CODES. PROPER GROUNDING IS REQUIRED FOR SAFETY.
WE STRONGLY ENCOURAGE ONLY A LICENSED ELECTRICIAN INSTALL, OPERATE AND MAINTAIN THIS
PRODUCT. IF YOU ARE NOT QUALIFIED OR UNFAMILIAR WITH ANY ASPECT OF THIS INSTRUCTION SHEET,
CONSULT AN ELECTRICIAN. THERE ARE NO SERVICEABLE PARTS INSIDE.
WARNING:
MAKE SURE POWER IS TURNED
OFF
BEFORE STARTING THE
INSTALLATION OR PERFORMING ANY MAINTENANCE.
RISK OF FIRE/ELECTRIC SHOCK –
DISCONNECT POWER AT BREAKER BEFORE INSTALLING OR SERVICING.
RISK OF PERSONAL INJURY –
FIXTURE MAY BECOME UNSTABLE OR DAMAGED IF NOT INSTALLED PROPERLY.
RISK OF BURN –
ALLOW FIXTURE TO COOL BEFORE SERVICING.
The Larson Electronics TPM-2XLEDEQ-4X3-CPR LED Pole Light is a pole lighting solution with outdoor and rugged
applications. This 120-watt unit consists of two high output LED fixtures, which are capable of emitting 8,400 lumens of
white light. The telescoping pole is adjustable at heights between 3 and 8.5 feet. Operators can manage power
connections seamlessly using a 20` wiring harness with a weatherproof quick disconnect.
MOUNTING AND SETUP
The adjustable telescoping pole is designed to be mounted to any vertical surface via an
included mounting plate with four pre-drilled mounting holes. Users can simply attach the
mounting plate to a wall, trailer, the exterior of boat cockpits etc, then slip the pole into the
bracket and lock it into place using the T-handle screw. Once positioned, the aluminum pole can
be collapsed to 3 feet and extended to 8.5 feet by unlatching the locking brackets, extend the
pole to the desired length, and lock the brackets to hold in position. The top of the pole is fitted
with an aluminum mounting plate holding the two LED lamps. Each lamp can be rotated or tilted
to the desired position. Use the screws on the sides of the lamps for vertical adjustments, and
the bolt through the bottom bracket for horizontal adjustments.
WIRING
The TPM-2XLEDEQ-4X3-CPR comes with a 20` 16/2 wiring harness, which features a
weatherproof quick disconnect between the light and harness. Attach the harness to the lights
via the Deutsch connectors as shown.
Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
•
Cord is attached via a weatherproof 2-pin Deutsch connector.
•
The cord is detachable by depressing the tab on the top of the connectors. This
enables the
operator to remove and store the light while leaving the cord connected to the
power source.
•
Additional or replacement cords can be ordered from our website. Contact us or visit
LarsonElectronics.com for more
information.
QUICK DISCONNECT
DEUTSCH CONNECTOR
Once the harness is connected, complete the connections as appropriate for the cord
option
chosen
when ordering.
FLYING LEADS
We strongly encourage a licensed electrician install this product
,
in all locations,
especially in outdoor areas where weatherproofing may be required.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown in the
diagram
