SPG-4G-18-8-FM
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2 of
2
TOWING
1.
Do not exceed 55 mph on highways. Do not exceed any posted speed limits.
2.
Slow Down for curves, adverse weather, hazardous road conditions, constructions zones, emergency
vehicles and expressway exits.
3.
Larson Electronics does not recommend using cruise control or overdrive when towing.
4.
Allow at least 4 seconds between you and the vehicle in front of you.
5.
Persistent side to side motion is not norm
al
. If this occurs at a certain speed, it is a signal that
whipping
will likely occur if speed is increased. If you notice this behavior, immediately slow down and
maintain
at least 10 mph below the speed when the sway was first noticed.
TRAILER PREPARATION
Prepare the trailer for mast deployment.
1.
Position the trailer in a location as close to level as possible.
2.
Extend all four (4) outriggers located at each corner of the
trailer. This is done by loosening the “T” Handles
(shown in picture)
on top of
each outrigger and pulling them out. Rotate each jack
perpendicular with the ground and lock in place.
3.
Using the jacks on the outriggers, level the trailer before using. Adjust each jack to achieve proper
leveling. Turning the handles clockwise raises the jacks and counterclockwise lowers the jacks
.
4.
Once trailer is leveled and stable, the mast may now be raised. Rotate the winch handle to raise
mast to desired height, and rotate in the opposite direction to lower it back down.
NOTE: The T-
Head mast supports up to 120 lbs. DO NOT overload.
5.
Before towing, be sure outriggers are retracted and jacks are turned horizontal for transportation.
Reconnect trailer light cable, and use tow chains.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
SP
G
Series
is designed to provide years of reliable performance. Should the need for replacement parts arise,
please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
