PML-90LED-DP-120
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
WIRING
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 100V - 277V AC, 50 or 60Hz
except those factory ordered with low voltage
9
V to
50
V AC/DC.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
Low Voltage DC
Connect power to power supply outputting low voltage between 9-
50
Volts DC.
This variable voltage allows greater versatility without affecting light output. Ensure
deutsch connectors are properly connected (If applicable)
DETACHABLE CORDS
•
Cord is attached via a weatherproof 2-pin Deutsch connector.
•
The cord is detachable by depressing the tab on the top of the connectors. This enables the
operator to remove and store the light while leaving the cord connected to the power source.
•
Additional or replacement cords can be ordered from our website. Contact us or visit LarsonElectronics.com for more
information.
DURABILITY
This light has a 4 inch square steel mounting plate that is secured to the mounting surface via 4 screws. The mounting
assembly on this unit allows the unit to be rotated and adjusted vertically. The adjusting hinges on this light are tensioned,
allowing the user to simply position the light as desired without any need for locking the unit into place. Once positioned,
the light will hold its position until the user again repositions it.
MOUNTING
This series of LED light bars from Larson Electronics offers IP68 rated construction that is designed to withstand
demanding environmental and operating conditions. These units can withstand frigid temperatures, are waterproof to
three meters and resist ingress of dust, dirt and humidity. The housing on this unit is formed from cast aluminum, the
control handle is solid polycarbonate and the lens is unbreakable polycarbonate. The Seoul Z-Power LEDs offer excellent
resistance to shocks and vibrations and are rated at 70% lumen maintenance after 50,000 hours of use.
