Larson Electronics, LLC
Phone: 877-348-9680
Fax: (903) 498-3364
2
of
10
Introduction and Installation Notes
HIGH VOLTAGE – Risk of Electrical Shock. This equipment is connected to
line voltage that can create a potentially hazardous situation.
•
Always make certain power is off before servicing this equipment.
•
Do not connect control circuits to T3.
•
Do not connect a ground or neutral to T3.
•
Make sure static phase converter and equipment are properly grounded.
•
Wire recommendation is based on the use of copper wire. If using aluminum wire, use the
copper equivalent for current amount.
•
For indoor use.
•
Humming and clicking noise is normal when power is applied to converter.
•
Installation of this equipment must comply with all national, state and local electrical codes.
•
Installation must be performed by qualified licensed electrician who should have
experience working with this line voltage.
Wire and Breaker/Fuse Sizing
Refer to the table on page 5.
MTPC-SCHD Series