ver.0818-1
LM
-EW
Series Light Masts
Larson Electronics, LLC.
3
The light mast ships with the light head / T-head removed to prevent
damage during transport. Follow the steps below for installing or removing
light head.
1.
Locate light head. Color, style, and mounted lights will vary.
2.
The light head is equipped with a T-
Handle / Hand Screw.
3.
Make sure the hand screw is loose, to
allow the head to slide over the top
stage of the mast.
MAST HEAD INSTALLATION
COLOR MAY VARY
4.
Using a pair of slings, wrap both slings around the light head in between
the lights on both sides.
5.
Attach the slings to a forklift or other lifting device.
6.
With 2 people holding the light head steady, slowly raise the light head
above the mast.
7.
A ladder will need to be placed on both sides of the mast, in order for 2
people to guide the head in to place.
8.
Once the light head is on top of the light mast, tighten the T-Handle to
ensure the light head is safely secured to the top of the mast.
9.
Make the electrical connections for the
lights. Repeat this process in reverse
order for removing the light head.
10.
Proceed to the
OPERATION MANUAL
for operating the unit.
Slings are recommended for installing heavy loads and to ensure operator
safety. Should other methods be used, Larson Electronics shall not be held
responsible for damages or personal injuries.
