![background image](http://html1.mh-extra.com/html/larson-electronics/ledsb-3xqf12v-1227-wf-3xkt/ledsb-3xqf12v-1227-wf-3xkt_installation-and-mounting-manual_3877003002.webp)
Larson Electronics LLC WWW.
LARSONELECTRONICS
.COM
9419 E US HWY 75, Kemp, TX 75143 - P: 903-498-3363 F: 903-498-3364 E:
OPERATION:
Synchronization (Permanent Mount Only):
To sync two beacons, configure both lights to display the same Phase 1 pattern. With the power off,
connect the YELLOW wires from each light together. When the lights are activated, their patterns will be
synchronized. To configure the two lightheads to alternate their patterns, advance the pattern of either
beacon to the Phase 2 mode of the current pattern. A maximum of 8 lights may be synchronized.
Setting the Flash Pattern (Magnetic Base):
Depress the rocker switch on the lighter plug:
Less than 1 second for the NEXT pattern
1 to 3 seconds for the PREVIOUS pattern
3 to 5 seconds for the DEFAULT pattern
Greater than 5 seconds to TURN OFF the beacon
Setting the Flash Pattern (Permanent Base):
Connect Blue wire to the Black wire (chassis ground):
Less than 1 second for the NEXT pattern
1 to 3 seconds for the PREVIOUS pattern
3 to 5 seconds for the DEFAULT pattern
Greater than 5 seconds to TURN OFF the beacon
MAINTENANCE
The beacons are completely sealed units designed to be maintenance free. Refer to the guide below for
help with troubleshooting. Should the unit be diagnosed as malfunctioning, remove unit and replace
with a new module.
TROUBLESHOOTING
Problem
Probable Cause
Remedy
Lighthead does not activate
a. No power to unit
a. Check wire for loose connection
b. Power input wire reversed
b. Reverse power wires
c. Damaged or shortaged cabling
c. Check cables for damage
d. Defective lighthead
d. Replace lighthead module
Lighthead is constantly ON
a. Control wire permanently
grounded or shorted to GND
a. Avoid permanent grounding of
control wire
Remote:
Use the remote to turn the light on and off.
100'
Range (Includes 1 Remote per Light for Total of 3).