![background image](http://html1.mh-extra.com/html/larson-electronics/ledp5w-30-tp1-50cr/ledp5w-30-tp1-50cr_quick-start-manual_3874678003.webp)
Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
SERVICE INSTRUCTIONS
Maintain reel by following the service instructions given below. Refer all other repairs, other than those
listed, only to an authorized service person or directly to Larson Electronics. Failure to do so can result in
personal injury and/or equipment damage and may void the warranty.
WARNING:
Remove power from reel before performing the following procedures.
SPRING TENSION
If necessary, adjust spring tension on reel by adding or removing wraps of electrical cord from spool,
one wrap at a time, until desired tension is obtained. Add wraps to increase tension. Remove wraps to
decrease tension.
WARNING:
When adding wraps of electrical cord, be careful not to exceed the winding mechanism’s
spring capacity. Add just enough wraps of cord to achieve the desired tension. Damage to the winding
mechanism will result if spring is over-tensioned.
Always beware of spring tension on reel. Exercise
extreme caution.
CAUTION:
To eliminate heating and damage to reel cord, pull all cord from reel if electrical load
approaches maximum rating.
TROUBLE SHOOTING INSTRUCTIONS
Troubleshooting of the reel consists of isolating a problem to a defective cord/work device, cable, or
light. Refer any other discrepancies only to an authorized service person or directly to Larson
Electronics.