IND-HL-HDB-FUVC-EX-1L-120V-15C
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
4
MOUNTING
The IND-HL-HDB-FUVC-EX-1L-120V-15C has a handle at the back of the unit for portable use. At <5 lbs., the lightweight design allows
the device to be held directly over the target surface or object with ease.
Lamp Replacement
:
Warning:
Do not touch bulb with bare hands. The oils in your skin will damage the lamp. Fingerprints will result in reduced performance
and significantly reduce the lifespan of the lamp unless removed with alcohol. Be sure fixture is disconnected from power source and
cooled off before servicing.
Replace old bulb with one of the same type and rating.
Remove the 2 plastic rivets located on either side of the handlamp near the lamp
tube. This will free the tube from the lamp base and allow you to pull it off and access the bulb. Carefully
remove
the old bulb
from
the
fixture and discard in accordance with any local or national regulations. Insert the new bulb
into the fixture and secure.
Place the tube
back onto the lamp and align the rivet holes between the tube and lamp base, then reinstall the rivets.
WIRING
This unit is equipped with 15 feet of 16/3 chemical and abrasion resistant SOOW cord that is fitted with an industrial grade cord cap for
easy connection to common wall outlets. Plug options include standard 5-15 15 amp straight blade plug for 110V wall outlets with
ground or NEMA L5-15 15 amp twist lock plug for 125V twist lock outlets. Alternatively, we can provide flying leads with no plug for hard
wire applications or for operators who prefer to wire in user provided cord caps. Please choose pigtail option below for flying leads with
no plug.
Standard pigtail(flying leads) wiring
We strongly encourage a licensed electrician install this product
, in all locations especially in outdoor areas
where weatherproofing may be required. Universal voltage driver permits operation at 1
20V AC, 60Hz.
Warning:
Check product label for correct input voltage!
Attach supply line wires to the appropriate light fixture wires as shown
in the diagram
Secure each pair of wires according to the diagram. Utilize a junction box or
similar device and take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the
unit. Ensure the unit is properly grounded and that wiring is done according to
all local and national electrical/building codes.
Standard Cord Cap
This unit comes pre-wired from factory with the selected cord cap. Take
precautionary steps for weatherproofing all connections if installed in a
location where water may come in contact with the unit. All outdoor
installations and indoor installations near a wet location require the use of a
GFCI device for safety, according to the National Electrical Code® (NEC).
Ensure the unit is properly grounded.
