Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
HAL-SL-10-20X-LED
WIRING
We strongly encourage a licensed electrician install this product,
in all locations, especially in outdoor areas where
weatherproofing may be required.
Warning:
Check product label for correct input voltage!
This unit comes pre-wired from factory with the selected cord cap. Take precautionary steps for weatherproofing all
connections if installed in a location where water may come in contact with the unit. All outdoor installations and indoor
installations near a wet location require the use of a GFCI device for safety, according to the National Electrical Code®
(NEC). Ensure the unit is properly grounded. Follow all applicable local and national electrical and building code when
installing to maintain safety within the hazardous area. This explosion proof LED string light is equipped with a 25 foot
whip of 16/3 chemical and abrasion resistant SOOW cord that is fitted with an explosion proof cord cap for easy
connection to explosion proof outlets. Plug option is selected when ordering, check product labels for specifications
before connecting to power source.
**PLEASE NOTE** voltage ratings on plugs and outlets are
MAXIMUM
voltage. For
low voltage
applications, proper
voltage must be applied to the outlet or damage to the light fixture will occur.
Position device near work area for operation. Run cable to nearby power source outputting the correct voltage as
identified on the product label. Insert and twist-lock explosion-proof plug into a compatible receptacle within the
hazardous environment.
See plug operation below.
PLUG OPERATION
Electrical connection between plug and compatible receptacle is accomplished after plug fully inserts into receptacle and
is rotated clockwise.
1.
Lift receptacle door and locate polarization on mating plug pin and
receptacle face. Insert plug straight all
the way into receptacle until it
cannot go further.
2.
Rotate plug clockwise limit (37º), this closes internal contacts and
completes circuit. This also mechanically
locks plug into receptacle so it
cannot be pulled out.
3.
To remove plug, push plug inward and turn to counterclockwise, pull plug
straight out.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-877-348-9680
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
OPERATION
The lamps are “instant-on” and will illuminate once power is supplied.
LAMP REPLACEMENT
1.
Loosen and remove guard (Turn counter-clockwise).
2.
Unscrew globe (Turn counter-clockwise).
3.
Remove and replace bulb with matching lamp.
4.
Inspect gasket(s). If worn or damaged, it must be replaced to insure watertight seal.
5.
Screw globe completely onto lamp base (Turn clockwise).
6.
Replace guard (Turn clockwise).
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the
life of the equipment.
Perform visual, mechanical and electrical inspections on a regular basis. We
recommend routine checks to be made on a yearly basis. Frequency of use and environment
should determine this. It is recommended to follow an Electrical Preventive Maintenance Program
as described in NFPA 70B: Recommended practice for Electrical Equipment.
Always check for
damaged or worn out parts before using the device. Inspect for good working condition prior to
storage and before re-use.
REPLACEMENT PARTS
The
HAL-SL-10-20X-LED
is designed to provide years of reliable performance. Should the need
for replacement parts arise, please contact Larson Electronics.
