![background image](http://html1.mh-extra.com/html/larson-electronics/gvp-48-2l-led-d-v2/gvp-48-2l-led-d-v2_instruction-manual_3777157002.webp)
GVP-48-2L-LED-D-V2
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
PREPARATION
•
Before beginning assembly, installation, or operation of product, make sure all parts are present.
Compare parts with the package contents list and diagram.
•
If any part is missing or damaged, do not attempt to assemble, install or operate the product.
TROUBLESHOOTING
PROBLEM
POSSIBLE CAUSE
CORRECTIVE ACTION
Light does not come on
No power to the fixture
Check if circuit breaker is tripped
Wiring to the unit is loose
---
Confirm fixture is properly grounded
QUESTIONS, PROBLEMS, MISSING PARTS
Before returning your fixture, please call Larson Electronics at 1-800-369-6671 or log on to
http://www.larsonelectronics.com for replacement parts.
WARNING
•
Always hire a licensed electrician for proper installation.
•
Always mount this fixture to a grounded junction/breaker box.
LIGHT ASSEMBLY
1.
Turn off the power at the main fuse or breaker box.
2.
Thread wires through wire gland and back cover wire hole.
3.
Connect the wires to the wire terminal L to L, N to N then fasten the wire gland.
4.
Connect 0-10V dimmer to associated wires. These are typically purple and grey but may differ per model.
Purple is positive (+) and grey is negative (-). Refer to dimmer instructions for connections.
Please note:
Use
appropriate dimmer switch that meets area classifications. Do not connect high voltage to dimmer wires!
5.
Attach to the LED tubes to the lamp holder.
6.
Put the tube fixing board in the back cover, fixing poles through the board
’s holes. Then turn around the
head of fixing poles 90° to fix the board to back cover.
Low Voltage DC
Connect power to power supply outputting low voltage between
11
-
25
Volts DC.
This variable voltage allows greater versatility without affecting light output. Ensure
deutsch connectors are properly connected (If applicable)
7.
Use the lens and back cover clips to attach lens to back cover.
8.
Use the wall fixing clips to fix the light fixture to the wall.
9.
Turn on power at main fuse breaker box.