![background image](http://html.mh-extra.com/html/larson-electronics/gl5150-12ir/gl5150-12ir_instruction-manual_676947002.webp)
The GL5150-12IR is a Portable Searchlight designed
to be permanently or temporarily attached to a
vehicle for your specific use. The 2-Speed
Searchlight with Directional Flexibility is controlled by
a wireless remote, which gives the operator a full
370° horizontal rotation and a 135° vertical tilt with
fingertip control. The GL5150-12IR provides superior
light
penetration with state of the art Infrared
technology.
GL5150-12IR Searchlight
Wireless Remote Control
Mounting Shoe (Press spring lock to release and
remove light.)
MOUNTING INSTRUCTIONS
Temporary (Suction):
1.
Always clean mounting surface with a clean
cloth.
2.
Remove light from permanent mount shoe by
depressing spring-loaded lock and sliding light
out.
3.
Place suction base on clean, dry surface and
move side lever into the locked position.
WARNING:
Check the suction cup frequently to
ensure
that
suction
strength
is
maintained.
Temperature variations, rough terrain, grease and
dirt affect the length of time that the suction cup will
remain in place. Suction mounting is not
recommended for road use.
Magnetic Mount:
1.
Select the best location on your vehicle for
the magnetic mount. Make sure the metal
area under the magnetic base is flat and
clean to ensure a strong bond.
2.
Route the power cord into the vehicle
through a door frame and connect to 12V
power outlet.
The magnetic mount Golight should be removed from
vehicle’s exterior while traveling at excessive speeds
and in strong wind conditions.
Route the power cord into the vehicle through a
door frame and connect to 12V power outlet.
PROGRAMMABLE REMOTE INSTRUCTIONS
The GL5150-12IR is controlled with a programmable
remote with 2187 different channels. This feature
allows you the freedom to change the channel
selection, and the receiver relearns the new
selection.
PROGRAMMING THE TRANSMITTER.
This light has been pre-programmed at the factory, it
is not necessary to re-program the transmitter, but is
recommended.
PROGRAMMABLE REMOTE INSTRUCTIONS
The GL5150-12IR Light is controlled with a
programmable remote with 2187 different channels.
This feature allows you the freedom to change the
channel selection, and the receiver re- learns the
new selection. This light has been pre-programmed
at the factory, and it is not necessary to re-program
the transmitter, unless you experience outside
interference. To program transmitter:
1. IMPORTANT
Disconnect power.
2.
Remove battery cover from remote control.
3.
Set the 7 dip switches to a selection of your
choice. There are 3 positions on each; positive,
negative and neutral. Use a small screwdriver and
select a position for each dip switch. *Please note
that the orientation of the +/- switch positions may
vary among different models of wireless remote
controls.
4.
Insert both GP 23A 12V batteries. Be sure
batteries have adequate charge.
5.
Replace battery cover.
a.
Depress the on/off button and hold it down.
Red LED will light.
b.
While holding the on/off button down,
reinstall the power (replace fuse or connect
vehicle battery).
c.
Keep on/off button depressed for 5-6
seconds, and then release. The light should
now be programmed.
BATTERY INSTALLATION AND REMOVAL FOR
TRANSMITTER
Remove Battery Cover: remove the Phillips head
screw securing the battery cover then remove the
cover. With the battery compartment now exposed,
insert batteries according to correct polarity.
Remove the batteries by gripping the positive end of
each battery and lifting.
Use only 12v-A23 batteries in the Golight remote
control