The GL-4600 is a 1-Speed Searchlight with
Directional Flexibility which gives the operator a full
360° horizontal rotation and a 180° vertical tilt with
fingertip control. The GL-4600 provides superior light
penetration with the new LED/PVEX lens technology.
MOUNTING INSTRUCTIONS
Light Unit/Permanent Mount
Determine the location for the light on your vehicle or
boat. Remove the mounting plate from the light.
Center the mounting plate. Mark the hole locations
for the four mounting screws and drill a pilot hole for
each with 1/8 inch bit. Fasten the stainless steel
mounting plate with the 3 #10
– 16x3/4 type AB
cross recessed pan head tapping screws. Drill a 1
1/
4” hole in the center of the mounting plate opening
to accommodate the wiring harness and connector.
Attach the connector that is affixed to the underside
of the light to the corresponding connector on the
wiring harness. Position the connection point
beneath the mounting surface, and apply silicone
sealant around wire to seal the drilled opening. Place
the light over the mounting plate. Install the set
screws (provided) and tighten.
Light Unit/Magnetic Mount
Select the best location on your vehicle for the
magnetic mount Stryker. Make sure the metal area
under the magnetic base is flat and clean to ensure a
strong bond. Route the power cord into the vehicle
through a door frame and connect to power outlet.
The magnetic mount GL-4600-M should be removed
from vehicle’s exterior while traveling at excessive
speeds and in strong wind conditions.
Dash Control/Permanent Mount
Determine the appropriate location for the dash
mount
control
and
create
an
opening
to
accommodate the board on the rear of the remote.
Affix the control to the dash with four screws. The
words should be facing upright and should be
situated accordingly. All wiring should be undertaken
with power removed from the system. First, attach
the connector that is affixed to the control to the
corresponding connector on the wiring harness.
Next, join the leads at the remote to 23-32V DC
power with appropriate automotive wire attachments;
the wire with (+) is the positive lead and the opposite
black wire is the negative lead--the unit is polarity
sensitive and care must be taken to observe this. As
a safety feature, the power switch is backlit to
indicate bulb illumination.
Each spotlight needs to be
wired on a single dedicated circuit and
the power
fused at 5 amps. With the power connected, your
light is
ready for operation.
OPERATION OF GL-4600
1.
Using the remote control, turn on the light by
moving the on/off switch.
2.
With the joystick on the dash control, rotate your
light to the desired location. Movement speed
starts off slow and increases speed as the joystick
is held down.
3.
Position the dial to use the desired light. WHITE
indicates the visible white LED light. IR indicates
infrared LED.
4.
Move the power switch ON to power on the
selected light.
5.
Press the HOME button to return the GL-4600
back to its original home position.
USAGE:
» This light is intended for off-road and utility use only
» This light is intended to be mounted outside the
vehicle while in use
» This light may only be disassembled and repaired
by an authorized representative
MISUSE:
» This light is not approved for road or highway use
» This light is not approved for underwater use
» This light is not approved for inverted mounting
» This light is not approved for use inside a vehicle or
enclosure and power should be disconnected prior to
placing the light in such circumstance
» This light may be damaged if operated in icing
conditions
» This light may only be dismantled by an authorized
Larson Electronics representative.
» Any violation of the above referenced misuses
will be considered grounds for warranty refusal
