Larson Electronics, LLC
Phone: (877) 348-9680
Fax: (903) 498-3364
www.larsonelectronics.com
5
of
6
Controller Setup
To set up the controller:
1.
Open the battery compartment by removing the #1 Phillips head screw and removing the cover.
2.
Install two AAA batteries in the orientation indicated in the battery compartment.
3.
Replace the cover and secure with the screw.
Pairing Procedure:
The search light and the controller shipped with it will be paired as #1. If this is lost, if adding additional search lights into
a controller’s memory, or if a replacement is needed, follow this pairing procedure.
1.
With the search light powered down, hold the desired Preset button for five seconds to begin the pairing procedure.
2.
When the button begins to flash blue, apply power to the search light.
3.
Wait until the Power button begins to flash green and the Preset button begins to flash red.
4.
To confirm the pairing, short press the Power button. The Preset button will turn solid green.
5.
To cancel pairing and continue to scan for a new search light, short press the Preset button. The Preset button will
begin to flash blue again.
6.
Repeat this procedure for the remaining two Preset buttons with additional search lights.
Setting the Memory:
1.
After moving the search light into position, hold one of the Memory buttons for five seconds until the Power button
blinks.
2.
The memory is now set, and the unit can be moved to this position by short pressing the Memory button.
Magnetic Mounting
DO NOT DRIVE WITH MAGNETICALLY-MOUNTED SEARCH LIGHT INSTALLED:
Because vehicle roof construction and driving conditions vary, do not drive a
vehicle with a magnetically-mounted search light installed. The search light could
fly off the vehicle, causing injury or damage. Repair of damage incurred because
of ignoring this warning shall be the sole responsibility of the user.
The holding power of magnetic mounting systems depends on the surface finish, surface flatness, and thickness of the
steel mounting surface. Therefore, to promote proper magnetic mounting:
•
Keep the mounting surface and magnets clean, dry, and free of foreign particles that prevent good surface contact.
•
Ensure that the mounting surface is flat.
•
Do not use a magnetic mounting system on vehicles with vinyl tops.
•
To prevent the sliding of the search light on the mounting surface, avoid quick acceleration and hard stops.
Magnetic mounting provides a secure, temporary mounting method for most installations. However, it is not intended for
use on the exterior of a moving vehicle.
To temporarily mount the search light to a vehicle with magnetic mounting:
1.
Place the light assembly on a level, steel surface. Ensure that the light is placed to promote maximum coverage and
range of the search light.
2.
Insert the plug at the end of the cable assembly into the 12-volt power outlet socket.
3.
Turn the power on and off using the power switch on the plug. To show that the power is on, a pilot light turns on.
4.
Use the remote to operate the light.
NOTE: The lighter plug has an integral fuse and power switch. The switch may be used to remove power from the light. If
direct connection to the power source (not using the cigar lighter plug) is desired, a user-supplied inline fuse holder and
five-amp fuse must be installed in the power cord’s ribbed (positive) lead.
GL-2051-M
