![background image](http://html1.mh-extra.com/html/larson-electronics/gau-kfa-ph-600k-tst/gau-kfa-ph-600k-tst_instruction-manual_676677006.webp)
Assembly
Model
MH-600T-KFA
Wheel support frame
Yes
Wheels and Axle
Yes
Wheel Caps
Yes
Front and Rear Handle
Yes
'
Handle Frame
Yes
Cord Wraps
Yes
Screws, Nuts, and Washers
Yes
Cotter Pins and Bushings
Yes
iiii
ti
�
�
�
�
Front Handle
Handle Frame
Screws (L)
Screws (S)
Flat Washers (S)
Flat Washers (L)
®®®®
am
mm
®®®®
Wheel Caps
(Black Rubber)
Bushings
Nuts
Wheels (Pneumatic)
Cord Wraps
Cotter Pins
Figure 3.
Component Identification
TOOLS REQUIRED
• MEDIUM PHILLIPS SCREWDRIVER
• OPEN OR ADJUST ABLE WRENCH
• LONG NOSE PLIERS
ASSEMBLING WHEEL & HANDLE
1. Slide axle through wheel support frame. Install wheel bushings,
flat washers (S) and wheel on axle.
NOTE:
When installing wheels, tube valve should face out from
support frame (Figure 2).
2. Place flat washers (L) and cotter pins on axle ends and bend
cotter pins with long nose pliers to secure.
3. Place wheel cap on flat washers (L) and put wheel cap in flat
washers (L) end.
4. Place heater on wheel support frame. Make sure air inlet end
(rear) of heater is over wheels. Align the holes on fuel tank
flange. Insert screws through handles (front and rear), fuel tank
flange, and wheel support frame as shown in Figure 2 and
attach nut finger tight after each screw is inserted.
5. After all screws are inserted, tighten nuts firmly.
I
A CAUTION
I
Do not operate heater without support
'--· _______ __,_
frame fully assembled.
GAU-KFA-PH-600K-TST
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
6
of
16