Bug Eye Emergency LED Fixture - 120/277V - (2) LED Lamps,
90-min Battery Backup - Wet Locations
INSTRUCTION MANUAL
IMPORTANT!
The battery in this unit may not be fully charged. After electricity is
connected to unit, let battery charge up for at least 24 hours. Then the
nonnal operation of this unit should take effect To check press the "TEST''
button and the lights on the unit should turn ON.
IMPORTANT SAFEGUARDS
When using electrical equipment, basic safety precautions should always be followed including the following:
READ AND FOLLOW ALL SAFETY INSTRUCTIONS
1. Rated for temperature range of l0°C-40-C (50
°
F-104
°
F) and suitable for use in an application that is designated as a damp location area as
defined by NEC Article 100, Location, Damp.
2. Used indoors or outdoors.
3. Equipment should be mounted in locations and at heights where it will not be subject to tampering by unauthorized personnel.
4. Do not mount near gas or electric heaters.
5. The use of accessory equipment is not recommended by the manufacturer and may cause an unsafe condition.
6. Do not use this equipment for anything other than its intended use.
7. Servicing of this equipment should be performed by qualified personnel.
8. Disconnect AC power before servicing.
SAVE THESE INSTRUCTIONS!
FLEXIBLE
CONDUIT
ONLY
INSTALLATION (J-BOX MOUNTING)
1. Open the Base plate and lead out a wire after getting through the hole on the Base plate. Fix the Base plate on J-Box with screws.
2. Then connect to AC power (Fig.A).
3. Connect to the battery with connectors (Fig.B).
4. Install the housing to Base plate, turn on the AC power and press the "TEST" button check light (Fig.C).
INSTALLATION (CONDUIT)
1. Secure Base Plate to wall surface. Route wires through hole in conduit flange and make conduit connection. Use flexible conduit only.
2. Connect battery only after continuous AC power is being supplied to the unit (Fig. B).
3. Align snaps and push housing directly onto the Base Plate (Fig. C). Apply continuous AC power and press "TEST" button to check light
Fli.AO-tca)
Fig.8
GAU-EMG-2X5W-LED-WP
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
