Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
OPERATION
Plug into any 110-125V standard wall outlet. Depress switch in handle to turn the light on. Plug
up to three (3) electrical appliances into the Triple-Tap outlet.
Pull the cord out to desired length and stop. If cord does not hold, continue to pull cord slowly,
stopping every four inches. This will engage lock. To retract, pull cord slowly, stopping every four
inches. This will engage lock. To retract, pull cord out 2 to 4 inches and guide the cord slowly
back into the reel.
NOTE:
1.
Outlet is un-switched and energized at all times. DO NOT OVERLOAD!
2.
Cord is 30 Ft fully extended; DO NOT pull on cord after cord is fully extended.
CAUTION:
To avoid possible injury
– Do not allow cord to fly back into the reel unrestricted. Guide cord
slowly back into the reel.
INSTALLATION
Ceiling Mount - 360° Rotation
1.
Select location within 2 feet of an electrical outlet.
2.
Screw the Hanger Hook into a stud in the ceiling.
3.
Hang the reel on the hook
4.
Use pliers to close the hook so the reel is secure and won’t fall off.
5.
Adjust cord stop so outlet hangs at desired length when cord is retracted.
6.
Plug the power cord into the outlet.
Optional Wall Mount - 180° Rotation
1.
Select location within 2 feet of an electrical outlet.
2.
Take U-Shaped bracket and attach to wall, in a stud, with the screws provided.
3.
Place Hanger Bracket inside U-Shaped Bracket lining up the small hole in the brackets.
4.
Insert Locking Pin through lined-up holes.
5.
Adjust cord stop so outlet hangs at desired length when cord is retracted.
6.
Plug the power cord into the outlet.
MAINTENANCE
Warning:
Unplug the unit before performing any maintenance.
Remove dirt and grime as soon as it accumulates. Use a soft, damp cloth and a mild soap, if needed. Be
sure not to get the electrical plug wet. NEVER submerge any part of the cord reel in any solution to clean
it. Do Not Use solvents such as gasoline, turpentine, etc. to clean unit. Keep reel cord clean to assure
smoothest automatic retraction. To clean, simply pull cord to its full length and allow retracting through
a dampened rag. Pull out full length again and allow to retract through clean rag sprinkled with talcum
powder.
DRY THROUGHLY BEFORE PLUGGING BACK INTO OUTLET.
