Larson Electronics LLC www.LarsonElectronics.com [email protected]
9419 E US HWY 175, Kemp, TX 75143 - P: (800) 369-6671 - F: (903) 498-3364
Run-Time between Charges
Flashlight - 9 hours, Full Floodlight – 9.75 hours, Half Floodlight – 13 hours, Dual-Light – 6 hours
CHANGING THE BATTERY PACK
1.
Remove the tail-cap and shake out the old RED battery
2.
Take a fully charged RED replacement battery and align the arrow on the battery with the notch
in the flashlight body.
3.
Slide the battery into the flashlight and replace the tail-cap. The flashlight is now ready for use.
Always
make sure the battery tab and notch in the housing are aligned.
Never
force the battery pack into the flashlight; this can cause the battery pack to become
lodged in the light housing.
SAFETY PRECAUTIONS
BRIGHT LED RADIATION: Avoid direct eye exposure
Do not charge this trouble light in explosive or hazardous areas.
Do not attempt to repair or disassemble the trouble light, the charger platform or the power
supply.
Use only the charging platform that is provided, AC or DC adapters and battery pack.
Using this product for other than a lighting device is not recommended. Larson Electronics
specifically disclaims liability for other than intended use.
FEATURES
The housing is chemical proof to most automotive and industrial chemicals. For Example:
Potassium Hydroxide, hydrochloric acid, sulfuric acid, isopropyl alcohol, Freon, gasoline,
kerosene, diesel fuel, antifreeze, hydraulic fluid and others. In addition to heptane, acetone,
methyl ethyl ketone (MEK), ethyl acetate, methylene chloride, ethylene glycol, benzene,
toluene. Avoid prolonged exposure and clean immediately.
The charging platform and light are electromagnetically compatible with FCC regulations CFR-47,
Part 15, Sub-Part B and Class A.
The trouble light is powered by a Nickel Metal Hydride (NiMH) battery pack and is earth friendly
so it can be disposed of in municipal waste without harm to the environment. (Excluding
California)
CHARGER PLATFORM MOUNTING
Mounting the charger platform requires two #8 screws (not provided).
Use the supplied 12 VDC fused auto adaptor plug for temporary vehicle installations.
For permanent wiring, the installation must be fused using a 3-amp in-line fuse.
