1of2
Package Contents
Tools Required:
Flathead screwdriver, Phillips screwdriver, pliers, wire cutters, wire strippers, electrical tape, safety glasses.
Bulb Recommended:
(3) Candelabra Base 60W Maximum
Estimated Assembly Time:
Preparation:
30-45 minutes
Identify and inspect all parts before beginning installation. Check package content list and diagrams below to be sure all parts are
present. If any parts are missing or damaged, do not attempt to assemble, install, or operate the fixture. Contact customer service for replacement
parts.
Warnings and Cautions
Turn off electricity at circuit breaker or main fuse box before installation. Consult a licensed electrician if in doubt.
These instructions are provided for your safety. It is very important you read them completely before installing the fixture. We strongly
recommend that a licensed, professional electrician perform the installation.
Disconnect fixture from power source before replacing bulbs. Make sure bulbs are given sufficient time to cool before removal. Do not subject
glass parts to any shock while in operation or shattering may result.
A
Mounting Screw
x 3
G
B
Loop
x 1
C
Waterproof
Washer
x 1
D
Support Block
x 1
E
Fixture Hood
x 1
F
Center Stem
x 1
Fixture
Body
x 1
STEP 1
Attach Fixture Hood and
Loop
-
A.
B.
C. Place Fixture Hood (E),
and
over
the top end of the Center Stem (F) in
turn. Secure them with the Loop (B).
Hand tighten until snug.
This fixture uses candelabra bulb with
standard screw base. Maximum 60
watts. Insert bulb and screw snugly
into place.
Thread the beaded end of the Center
Stem (F) into the mounting hole in the
center of the Fixture Body (G). Hand
tighten until snug.
Support Block
(D)
Waterproof Washer (C)
E
B
Bulb
Socket
C
D
Figure 1
F
G
Post
Post Fitter
STEP 2
Drill Pilot Holes on Post
-
A. Carefully fit the Post Fitter over the end of the Post (not supplied),
making sure the Post Fitter is fully seated.
B. Mark the drill point for the (3) Mounting Screws, using (3) Mounting
Holes as reference. After marking hole locations, remove fixture
from post and drill 1/16” pilot
holes for screws.
STEP 3 - Wire Connections
A. Use standard wire connectors (not included) to make all wire
connections. (Connectors are not included with fixture.) Twist
connectors until wires are tightly joined together. Wrap each
connection with approved electrical tape and carefully stuff all the
connected wires into the Outlet Box.
White wire
from supply
White wire
from fixture
Black wire from
supply (or Red)
Black wire
from fixture
Ground wire
from supply
Ground wire
from fixture
Figure 3
Figure 2
STEP 4
Attach Fixture Body to Post
-
A. Coat the top 1” of the Post with Clear
Silicone Caulk (not supplied) and
position the Post Fitter onto the Post.
Be sure to seat it completely, aligning
the holes in the Fitter with the 1/16”
Pilot Holes drilled into the Post.
B. Secure the Fixture to Post with (3)
Mounting Screws.
Your fixture is now assembled and
ready to use. Enjoy!
Post
Fitter
Post
Figure 4
Mounting
Screw
Installation Instructions:
UQL
1
203
