3
6.
Connect the extension cables to the camera drop cables. Use the protective jacket for the LAN cable
connector, if needed.
7.
8.
Tighten the mounting screws until snug. Be careful not to over-tighten them.
9.
Connect the extension cables to the devices the camera will connect to. Be sure the devices you
connect the cables to are not powered on.
10.
Apply power to the devices the camera is connected to, including 12 Vdc power or LAN PoE.
11.
Reinstall the junction box cover.
12.
needed.
13.
the camera including:
—
Install the Discover tool (see “Step 4. Install the Discover Tool” on page 3).
—
on page 3).
14.
Log into camera to perform camera setup procedures including:
—
Log in to the camera (see “Step 6. Initial remote login” on page 4).
—
For ceiling mounted cameras, select the
Mount Type
as “
Ceiling
”. For wall mounted
cameras, select the
Mount Type
as “
Wall
”. For table mounted cameras, select the
Mount
Type
as “
Table
”.
—
—
Change administrative password. See “Step 10. Change default password” on page 6.
IP Camera
Software User Manual
provided with your system, or on your vendor’s website. These
—
—
—
—
Traversing Virtual Plane Detection
—
Intrusion Detection
—
Add access users to the camera
Step 4. Install the Discover Tool
The Discover Tool is a software utility used to “discover” cameras and NVRs/DVRs installed on
the LAN and change their network settings. The tool is
available for download at the link below
.
Download Link: https://www.larsonelectronics.com/images/upload/SADPTool.zip
To use the tool:
1.
Unzip and open the SADPTool.exe file
on the Microsoft Windows computer you will use to access
your camera on the LAN.
4.
Discover Tool.exe
. The tool will
automatically discover cameras and recorders installed on the network.
Step 5. Change device network settings (IP address)
To change the network settings of the camera to be compatible with the subnet where it is installed, do the
following:
1.
Click the device to highlight it. Notice that the network parameters are shown in the right frame.
2.
Modify the network settings to values compatible with the subnet where it is installed.
3.
Enter the
admin
admin
user
password for cameras is
ChangeMeN0w
zero
/
4.
Click the
Save
EXPCMR-IP-POE-DPTZ
www.larsonelectronics.com
