Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
MOTION SENSOR
Operating voltage
Rated load
HF system
5.8GHz±75MHz, ISM wave band
Transmitting power
<0.5mW
Power consumption
≤
0.5W(standby)
Detection zone
Max.(D x H): 16m x 15m
Detection sensitivity 25% / 50% / 75% / 100%
Hold time
5s / 30s / 90s / 3min / 20min / 30min
Daylight sensor
5Lux/15Lux/30Lux/50Lux/100Lux/Disable
Mounting height
15m Max.
Motion detection
0.5~3m/s
Detection angle
150°(wall installation)
360°(ceiling installation)
Operating temperature -20
℃
~60
℃
IP rating
IP20
Setting
ON
ON
ON
ON
ON ON ON
ON ON
ON
ON
ON
ON ON
ON ON ON
ON
ON
ON
ON
I
II
III
IV
1 2
100%
75%
50%
25%
I
II
III
IV
V
3 4 5
IV
5s
30s
90s
3min
20min
30min
I
II
6 7 8
Disable
50lux
15lux
5lux
30lux
III
IV
V
Detection area can be reduced by selecting the combination on the
DIP switches to fit precisely each application.
Refers to the time period the lamp remains at 100% illumination after
no motion detected.
The sensor can be set to only allow the lamp to illuminate below a
defined ambient brightness threshold.
When set to Disable mode, the daylight sensor will switch on the lamp
when motion is detected regardless of ambient light level.
30lux, 50lux,100lux,:twilight operation, 5lux, 15lux: darkness operation only.
By selecting the combination on the DIP switch, sensor data can be precisely set for each specific application.
100lux
ON
ON
ON
ON
ON ON
When set to Disable, the microwave sensor function is inactive, lights turns on or off
by switch.
When set to Sensor, the microwave sensor function is active.
ON
Detection area
Hold time
Daylight sensor
Mode
EXP-AKC-MS-N4X-AT-LV-12V
