![background image](http://html1.mh-extra.com/html/larson-electronics/eps-pb10-2xc-m2-yr/eps-pb10-2xc-m2-yr_instruction-manual_3759639002.webp)
EPS-PB10-2XC-M2-YR
Larson Electronics, LLC
Phone:
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
MAINTENANCE:
For detail of parts, refer
to graphic below
. To prevent binding,
the knob and collar area should be cleaned periodically.
INSTALLATION
We recommend only a licensed electrician install this product. All applicable local and
national electrical and building code should be followed when installing.
EPS-PB10-2XC-M2-YR
devices are for surface mounting in hazardous
atmospheres, as defined in
the NEC Article 500. They contain an electrical device, and must have conduit sealing fittings (per
NEC article 50 1-5) on all conduit openings. Use Larson Electronics "EYM" series (or equivalent).
Mount the box using the cast mounting lugs provided. Install sealing fittings as required in Class I &
IT areas.
Thread conduit on to seals (
NOTE:
FOR CLASS I AREAS, CONDUIT MUST ENGAGE A
MINIMUM OF 5 FULL THREADS). The conduit threads should be lubricated with a non-electrical
insulating lubricant, or pipe joint compound which will not promote corrosion or chemically attack
aluminum.
After conduit system has been properly installed, pull the supply wires and make wiring
connections as required. The electrical circuits and ground continuity should be checked with an
instrument approved for the area.
A FLAME PATH IS MACHINED ON BOX & COVER SUCH THAT A 0.0015" FEELER GAUGE WILL
NOT ENTER THE JOINT MORE THAN 1/8" WHEN FULLY ASSEMBLED AND BOLTED. CARE
MUST BE TAKEN THAT MACHINED SURFACES AND THREADED AREAS ARE NOT
DAMAGED.
REMEMBER TO SAVE ONE OF THESE SHEETS FOR MAINTENANCE PERSONNEL.
(877) 348-9680
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of children
when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
EPS-PB10-2XC-M2-YR
is designed to provide years of reliable performance. Should the need for replacement parts
arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT
1-877-348-9680
FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.