![background image](http://html1.mh-extra.com/html/larson-electronics/eplc2-led-50w-rt-jb5/eplc2-led-50w-rt-jb5_instruction-manual_676801002.webp)
EPLC2-LED-50W-RT-JB5
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
2
WIRING
(see attached wiring diagram)
This unit comes preconfigured with selected voltage, and beam
angle. Position device near work area for operation. Run cable to
nearby power source. Insert and twist-lock explosion-proof plug
into a compatible receptacle within the hazardous environment.
See plug operation below.
PLUG OPERATION
Electrical connection between plug and compatible receptacle is
accomplished after plug fully inserts into receptacle and rotated
clockwise.
1.
Lift receptacle door and locate polarization on mating plug
pin and receptacle face. Insert plug straight all the way into
receptacle until it cannot go further.
2.
Rotate plug clockwise limit (37º), this closes internal
contacts and completes circuit. This also mechanically
locks plug into receptacle so it cannot be pulled out.
3.
To remove plug, push plug inward and turn to
counterclockwise, pull plug straight out.
Follow all applicable NEC, local, and state electrical codes.
MAINTENANCE
Caution:
To avoid personal injury, disconnect power to the light and allow the unit to cool
down before performing maintenance.
Warning:
No user serviceable parts inside of fixture. Risk of electric shock. Removal of the lens
will void the warranty.
1.
Perform visual, mechanical and electrical inspections on a regular basis. We recommend
routine checks to be made on a yearly basis. Frequency of use and environment should
determine this. It is recommended to follow an Electrical Preventive Maintenance Program
as described in NFPA 70B: Recommended practice for Electrical Equipment.
2.
The lens should be cleaned periodically as needed to ensure continued photometric
performance. Clean the lens with a damp, non-abrasive, lint-free cloth. If not sufficient, use
mild soap or a liquid cleaner.
3.
Inspect the cooking fins on the luminaire to ensure that they are free of any obstructions
or contamination (i.e. excessive dust build-up). Clean with a non-abrasive cloth if
needed.
4.
Do not operate if the lens is cracked or damaged. All fasteners should be properly seated.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
WARNING:
CHECK NAMEPLATE
FOR PROPER VOLTAGE.
DAMAGE FROM IMPROPER
VOLTAGE MAY VOID
WARRANTY.