OPERATION
Operate this pilot light only at its rated voltage. These devices are
individually
pre-sealed. Therefore, the enclosure in
which they are installed
does
not be
require
external seals. However, the enclosure
must
be marked with a cautionary
statement such as “Caution: Disconnect this device from the supplying circuit before entering. Keep assembly tight while
circuits are alive”. This statement must be permanently visible after the enclosure has been installed.
MAINTENANCE
The
Pilot Light require no special maintenance, other than a periodic inspection for damage or a burned-out lamp. To
replace the lamp, unscrew the lens/guard assembly. Replace the lamp
only
with one of exactly the same type and rating.
The lens assembly threads should be lubricated occasionally to prevent from binding.
Damaged or worn parts should be replaced immediately to ensure the safety of the system. Refer to the Parts Drawing
below. Consult Larson Electronics for specific part numbers.
EPCS-PL-2X-RG
Larson Electronics, LLC
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
Phone:
877-348-9680
