DCP-1205
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
3
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
OPERATION:
1 INSERT AC POWER PLUG IN
T
O A 110V VOLT AC OUTLET.
2 CONNECT THE POWER CO
R
D OF YOUR EQUIPMENT (13
.5
V - 14
.
1VDC} TO THE OUTPUT BINDING
POST TERMINALS ON THE FRONT OF THE UNIT
.
BE SURE THAT POLARITY IS CORRECT
.
THE RED
POSITIVE (+)
TERMINAL AND BLACK NEGATIVE ( -
)
TERMINAL ARE MARKED. REVERSAL OF POLARITY
MAY DAMAGE YOUR EQUIPMENT
.
3 TURN SWITCH TO "ON". RED LIGHT IN SWITCH WILL ILLUMINATE
.
4 THE INPUT POWER IS PROTECTED BY THE FUSE WHICH IS LOCATED AT THE REAR OF THE UNIT
AND CAN BE REPLACED BY UNSCREWING THE FUSE HOLDER IF THE FUSE IS BURNT OUT DO NOT USE
A FUSE LARGER THAN • • AMPS. USE OF HEAVIER FUSE MAY RESULT IN DAMAGING TO THIS UNIT
.
5 THIS UNIT HAS ELECTRONIC OVERLOAD PROTECTION WITH INSTANT AUTOMATIC RESET FUNCTION
IF OUTPUT IS OVERLOADED THE OUTPUT POWER WILL AUTOMATICALLY SHUT OFF RELEASE POWER
CORD O
F
YOUR EQUIPMENT FROM THE OUTPUT TERMINALS AND CHECK THE ACTUAL POWER RATING
OF YOUR EQUIPMENT THIS UNIT WILL AUTOMATICALLY RESET INSTANTLY.
6 OVER TEMPERATURE PROTECTION
CIRCUITRY IS USED IN
DCP-1205
TO PREVENT OVER
HEAT DAMAGE UNIT WILL BE SHUT DOWN MINUTES AFTER 15 MINUTES( MIN ) AT 100% RATED LOAD.
25 MINUTES( MIN.) AT 8
0
% RATED LOAD
7. THIS UNIT FEATURED WITH A CAR CIGARETTE JACK FOR THE CONVENIENCE OF YOUR MULTIPLE
CHOICES.
CAUTIONS:
1 DO NOT USE WITH EQUIPMENT
REQUIRING
MORE THAN RATING AMPS
2 DO NOT USE OUTDOORS DO NOT EXPOSE UNIT TO RAIN, MOISTURE. WATER OR
ANY OTHER LIQUIDS.
3 DO NOT REMOVE COVER IN ANY CASE. RETURN TO DEALER FOR REPAIR IF
DAMAGED.
4 THIS UNIT HAS A SPECIAL
BUIL
T-IN FEATURE THAT WILL SHUT THE UNIT
DOWN
IF MARKED
AMPERAGE IS EXCEEDED THIS WILL AVOID BURN-OUT OF YOUR EQUIPMENT AND OF UNIT. IF UNIT
DOES CONSISTENTLY SHUTDOWN THIS MEANS YOU ARE DRAWING TOO MUCH AMPERAGE RETURN
UNIT TO PLACE OF PURCHASE AND UPGRADE TO NEXT AVAILABLE UNIT OFFERING HIGHER
AMPERAGE. PLEASE DO NOT BYPASS OR AL
TER
THIS CIRCUIT AS IT IS THERE TO PROTECT YOU ANY
ALTERATION OR MISUSE WILL VOID YOUR WARRANTY
'$1*(5
+,*+92/7$*(
5()(57248$/,),('7(&+1,&,$1)256(59,&(
