Part # BLG-LEDBLT-SP131
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
1
of
2
BLG-LEDBLT-SP131
18 Watt LED Replacement Engine for BLG-LEDBLT-HGL
Instruction Manual
Thank you for your purchase of the 18 Watt LED Replacement Engine for BLG-LEDBLT-HGL, the following instructions
are intended for this part number only.
REPLACEMENT:
To install the new LED Light, remove all fasteners securing the old LED in
place. Remove the screws holding the protective LED housing onto the
light to remove the housing. Loosen or take out the two bolts on each side
of the top of the tightening clamp in order to free the LED. Remove the
old LED and put the new one in its place, tighten the bolts on the clamp
and reinstall the protective housing around the front of the LED.
Wiring and
Plug:
This replacement LED engine comes equipped with
an 18" whip cable that is terminated in a Deutsch connector.
Simply plug in the connector from the light to the female
Deutsch connector.
