BLG-LED-4REX-GRN
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
3
of
3
CHARGING
Fully charge your flashlight before first use. Several charge/discharge cycles may be
needed to achieve full battery capacity. The flashlight may be stored in the charger
continuously when not in use. To charge the flashlight, first turn it off and insert it into
the charger. The triangular plate on the head fits into a mating recess in the charger.
With the plate toward the charger, slip the barrel of the light between the charger
arms and pull downward until it locks into place. The red LED on the charger housing
must light to insure that the battery is being charged. Keep the flashlight and charger
contacts clean at all times. Poor contact can cause charger malfunctions. An abrasive
pencil eraser works well to clean the contacts. It should be fully charged in 12 hours.
Red LED remains on as long as flashlight is in the charger.
Observe the red LED:
•
If the LED does not blink rapidly and continuously, indicating a full charge, within
3.25 hours check the contacts and the charger’s power supply wiring. If no
obvious problem is found, return the system for service.
•
Proper function of the fast charge circuitry can be determined by inserting a
flashlight into the charger for at least 5 minutes. Turn the flashlight “on” and the
red LED should switch to blink mode within 5 minutes. The fast charger is
equipped with circuitry to prevent fast charging in temperature extremes (below
40° F and above 115°)
•
When temperature is within the acceptable range fast charging will begin.
BATTERY REPLACEMENT
Simply unscrew the tail cap and slide the battery from the flashlight. Replace the battery inserting the contact
end first and reattach the tail cap.
•
Replacement Lens (
BLG-LED-4REX-198
)
•
Replacement Battery (
BLG-LED-4REX-104
)
•
Replacement LED Module (
BLG-LED-4REX-131
)
•
Replacement Collar (
BLG-LED-4REX-130
)
•
Replacement Mount Bracket Assembly (
BLG-LED-4REX-132
)
MAINTENANCE
There are no serviceable parts inside the fixture. However, it is good practice to routinely clean and check the
fixture for proper function.
•
Disconnect power running to the lamp and be sure the fixture is cool to the touch.
•
Use a non-abrasive glass cleaning solution to clean the lens.
Note: It is not necessary to open the fixture and clean or touch the LED’s.
USE AND CARE
Unauthorized modification may impair the function and/or safety of this device and could affect the life of the equipment.
Always check for damaged or worn out parts before using the device. Store it in a secure place out of the reach of
children when not in use. Inspect for good working condition prior to storage and before re-use.
REPLACEMENT PARTS
The
BLG-LED-4REX-GRN
is designed to provide years of reliable performance. Should the need for replacement parts
arise, please contact Larson Electronics.
THESE INSTRUCTIONS MAY NOT COVER ALL DETAILS OR VARIATIONS OF THIS PRODUCT FOR YOUR EQUIPMENT OR INSTALLATION REQUIREMENTS.
SHOULD FURTHER INFORMATION NOT COVERED BY THESE INSTRUCTIONS BE REQUIRED, PLEASE CONTACT LARSON ELECTRONICS BY EMAIL AT
OR BY PHONE AT 1-800-369-6671 FOR FURTHER ASSISTANCE.
PLEASE VISIT LARSONELECTRONICS.COM FOR
WARRANTY
AND
RETURN
INFORMATION.
