BLG-LED-4REX-GRN
Larson Electronics, LLC
Phone: (800) 369-6671
Fax: (903) 498-3364
www.larsonelectronics.com
2
of
3
WARNING
TO AVOID THE RISK OF FIRE, EXPLOSION OR ELECTRIC SHOCK, THIS PRODUCT SHOULD BE INSTALLED,
INSPECTED AND MAINTAINED BY A QUALIFIED ELECTRICIAN ONLY, IN ACCORDANCE WITH ALL
APPLICABLE ELECTRICAL CODES.
TO AVOID ELECTRIC SHOCK:
•
BE CERTAIN ELECTRICAL POWER IS OFF BEFORE AND DURING INSTALLATION AND MAINTENANCE.
•
PRODUCT MUST BE CONNECTED TO A WIRING SYSTEM WITH AN EQUIPMENT-GROUNDING
CONDUCTOR.
TO AVOID EXPLOSION:
•
MAKE SURE THE SUPPLY VOLTAGE IS WITHIN THE VOLTAGE RATING.
•
ENSURE THE MARKED T RATING IS LESS THAN THE IGNITION TEMPERATURE OF THE HAZARDOUS
ATMOSPHERE.
•
DO NOT OPERATE IN AMBIENT TEMPERATURES ABOVE THOSE INDICATED ON THE PRODUCT
NAMEPLATE.
•
DO NOT OPERATE IF THE LENS, CORD, SEALS, HOUSING, RECEPTACLES, ETC. IS CRACKED OR
DAMAGED. IF SO, DISCONTINUE USE AND CONTACT MANUFACTURER FOR REPLACEMENT PARTS.
•
ALL FASTENERS SHOULD BE PROPERLY SEATED.
WARNING:
•
DO NOT CHARGE BLAST GUN LIGHT WITHIN HAZARDOUS AREA. REMOVE THE LIGHT FROM ITS MOUNT
AND CHARGE IT OUTSIDE OF THE HAZARDOUS LOCATION.
INSTALLATION
MOUNTING TO BLAST GUN
Mount the U-bracket from the blasting light to any standard blasting gun.
Two bolts keep the bracket in place.
INSTALL/REMOVE LED MODULE
Remove the four screws at the front of the protective lens cap on the gun
mount. Once removed, separate the front cap from the rest of the mount.
Wiggle the light back and forth until you are able to slide it through the
front of the mount. Insert the new light by placing the back end of the
light through the mount and pull tight to ensure it is snug. Replace the
protective lens cap and re-insert the four screws to fasten the cap to the
mount.
NOTE: Install protective lens prior to use in the field!
OPERATION
•
The light features a Head
‐
mounted push button Switch
•
Depress the push button switch once to turn the light on at full intensity.
Depress and hold the switch for one second for low intensity.
•
Depress and hold the switch for ten seconds for a very low intensity. (Moonlight
Mode) A single press of the switch from any “on” mode will turn the flashlight
off.
The Larson Electronics BLG-LED-4REX-GRN Explosion Proof LED Blasting Gun Light has a 4 watt LED that produces
130 lumens of intense LED illumination and is designed for extreme durability in media blasting applications. This
powerful green LED light is designed to be mounted to any standard blasting gun and is powered by rechargeable
batteries so no cords or transformers are necessary. This light will run for 4 hours at full power on a single charge. A
specially designed mounting system and quick change protective shield allows operators to use this unit as a blasting
gun mounted light source that will stand up to abusive use.
The protective lens is a simple slide in, slide out configuration. A slot in the bottom of the lens holder allows particles to
clear when performing lens changes.
