LT-300 User & Installation Manual
Service and repair
Lars Thrane A/S
www.thrane.eu
29 of 39
Service and repair
This section describes what the end-user must do in case of required service or repair.
NOTE:
The LT-300 GNSS Receiver does not require any scheduled maintenance or service. Make sure
that the product is installed, as described in this manual, before making contact to the
distributor or dealer for further assistance.
For troubleshooting the LT-300 GNSS Receiver, see Troubleshooting on page 30.
If the LT-300 GNSS Receiver for some reason does not work as described in this manual, make contact to the
distributor or dealer, from where the product was originally bought. The distributors or dealers will have
experience and know-how to assist with further technical support and troubleshooting.
Contacting the distributor/dealer:
1)
Make sure to have the product name (LT-300 GNSS Receiver), Part Number (P/N: 51-100304), and
the unit serial number (S/N: XXXXXXXX) identified. The unit serial number is listed on the outside of
the device (pole mount).
2)
Write a technical report about the observation or error. If possible, attach a picture of the installed
product and include a wiring diagram. If possible, make a diagnostic report with the LT-Service Tool
(see Configuration using LT-Service Tool on page 26).
3)
Send all information to the local distributor or dealer.
IMPORTANT: Unless otherwise agreed, the end-user shall always coordinate service and repair issues
directly with the distributor or dealer. This practice also applies for returning of products for
service and repair.
All information that will get back to Lars Thrane A/S, either directly or indirectly, will be handled with
confidentiality. End-user sensitive data will not be shared with any third party without prior written
acceptance from the involved parties.
Summary of Contents for LT-300
Page 2: ......
