LT-4200 User & Installation Manual Rev. 1.00
Web server
Lars Thrane A/S
www.thrane.eu
Page 79 of 128
Accessing the built-in web server
To access the built-in web server of the LT-4200 system, please complete the following steps:
1.
Connect the LT-4210 Control Unit directly to a PC using an Ethernet cable or connect the LT-4210
Control Unit to a Local Area Network (LAN), where a PC is connected.
2.
Identify the IP address that is assigned to the LT-4210 Control Unit. The IP address can be read out
from the display (MENU -> System -
> Network: IP Address). The IP address is valid if the ‘Link
Status’ is showing ‘Up’. The IP address is assigned dynamically
by a DHCP server.
3.
From the PC, start a browser (e.g. Microsoft Edge, Explorer, Chrome, etc.) and type in the IP
address, which was identified in the LT-4210 Control Unit (e.g. 10.1.10.39).
4.
The browser might show you a warning about an invalid web server certificate, as illustrated in
Figure 94. Make sure, that you have typed in the correct IP address.
5.
Press ‘Details’ and you will be presented for an
extended page view (including a link), which will
direct you to the LT-4200 s
ystem dashboard ‘Go on to the webpage (Not recommended)’.
6.
You will now see the LT-4200 system dashboard.
Figure 94: Accessing the built-
in web server (“This site is not secure”).
Summary of Contents for Iridium Certus 200
Page 2: ......
Page 140: ......
Page 141: ...Lars Thrane A S Skovlytoften 33 2840 Holte Denmark www thrane eu...
