Ediz. 010 - 06/2015
PROCEDURE TO UNLOCK THE SUCTION GROUP BALL
Should the ball of the suction group be blocked, the unit does
not suck the product anymore.
Procedere to manually release the ball as follows:
• Press several times the suitable device (
G6
).
ALARMS
• Flashing lamp (
G4
) for alarms:
NEVER point the spray gun towards yourselves
or other people. The contact with the casting can
cause serious injuries.
In case of injuries caused by the gun casting, seek
immediate medical advice specifying the type of
the product injected.
Recirculating-safety valve: when working at the
maximum pressure available, releasing the gun
trigger can cause sudden increases of pressure.
In this case, the recirculating-safety valve opens
automatically discharging part of the product from
the recirculating tube.
Then it closes so as to go back to the previous
working conditions.
SPRAY ADJUSTMENT
• Slowly turn clockwise the pressure control knob to reach
the pressure value in order to ensure a good atomization
of the product.
• An irregular and marked spray on the sides indicates a low
working pressure. On the contrary, a too high pressure
causes a high fog
(“overspray”)
and waste of product.
• In order to avoid overthickness of paint, let the gun advance
sideways
(right-left)
when spraying.
• Always paint with regular parallel bands coats.
• Keep a safety and constant distance between the gun
and the support to be painted and also keep yourselves
perpendicular to it.
PRESS
ALLARMI - ALARMS
WARNMELDUNGEN - ALARME
CORRENTE MASSIMA SUPERATA
MAXIMUM CURRENT EXCEEDED
MAX. STROM ÜBERSCHRITTEN
MAXIMUM COURANT DÉPASSÉE
SURRISCALDAMENTO HEAD CONTROL
OVERHEATING HEAD CONTROL
ÜBERHITZUNG HEAD CONTROL
SURCHAUFFAGE HEAD CONTROL
MOTORE IN CORTO CIRCUITO
MOTOR SHORT CIRCUIT
MOTOR IN KURZSCHLUSS
MOTEUR COURT-CIRCUITÉ
TENSIONE DI ALIMENTAZIONE ALTA
HIGH VOLTAGE FEEDING CURRENT
HOHE VERSORGUNGSSPANNUNG
TENSION D’ALIMENTATION À L’ENTRÉE TROP ÉLEVÉE
TENSIONE DI ALIMENTAZIONE BASSA
LOW VOLTAGE FEEDING CURRENT
NIEDRIGE VERSORGUNGSSPANNUNG
TENSION D’ALIMENTATION À L’ENTRÉE TROP FAIBLE
LED
1
2
3
4
5
For all alarms, the machine shuts down and signals
the type of abnormality by means of a series of
flashes.
As for alarm No. 6, light signalling through a se-
ries of uninterrupted flashes is provided without
machine shut-down. The operator must, however,
immediately connect the unit to an adequate
grounding system.
LARIUS assumes no responsibility for failure to
comply with this requirement.
www.larius.eu
JOLLY
14
G5
G6
