6. TROUBLESHOOTING
When the machine runs abnormally, the power indicator will blink in orange, and the machine will give
a voice prompt when some faults occur. Please refer to the table below for a solution.
Voice prompt/
fault phenomena
Please check if the
radar is stuck
The radar is blocked
or stuck
Remove the obstacle or move
the machine to an open place
and restart it
Please check the anti-colli-
sion rail
The bump sensor is
stuck
Clean up the foreign matters
around the anti-collision rail, or
move the machine away
Please wipe the cliff sensor
and move away from the
dangerous area to restart
The cliff sensor is
triggered after the
machine is started up
Please wipe the cliff sensor
and move the machine to a flat
and open place to start
Please check the main brush
The main brush is stuck
Clean the main brush, or move
the machine away
Please check the side brush
The side brush is stuck
Clean the side brush, or move
the machine away
Please check the main wheel
The main wheel is stuck
Clean the main wheel, or
move the machine away
The two-in-one water tank is
taken out
The two-in-one water
tank has been taken out
Please replace the two-in-one
water tank and the filter
screen, and confirm that the
filter screen and the
two-in-one water tank are
installed in place
Low battery, start recharging
Low battery during
cleaning
Low battery. Please charge the
robot before using
The fan is abnormal
The fan is abnormal
Please try to turn the machine
off and then restart it
Please wipe the wall-follow-
ing position sensitive
detector on the right side
The wall-following
position sensitive
detector is abnormal
Please wipe and clean the
wall-following position
sensitive detector
Possible causes
Solution
14
EN
If you have any questions, please email to [email protected]
Summary of Contents for L6 Pro
Page 1: ......
