11
4.
APS BUTTON
In RADIO mode:
1) When long pressing the APS button, the radio searches from the lowest frequency and
checks the signal strength level until 1 cycle search is finished. And then the 6 strongest
stations are preset to the corresponding preset number memory bank. The AS operation is
implemented in the each bank of the selected band. When the AS operation is finished, it will
scan each preset station for 5 seconds in FM or AM band from M1 as briefly pressing APS
button. After finishing a circle of scanning , it will resume broadcasting on the M1.(It can store
3x6 stations for FM and 2x6 stations for AM in all)
2) When briefly pressing the APS
button,
the radio will scan each preset station for 5
seconds in FM or AM band from M1. After finishing a circle of scanning, it will resume
broadcasting on the M1.
NOTE: In FM band, FM1,FM2,FM3 is checked one at a time.
In AM band, Am1, Am2 is checked one at a time.
5.
PRESET STATION [ 1-6 ] BUTTONS
In RADIO mode:
1)
To memorize the current frequency on the current band, long press any one of the six
preset buttons (1-6) .
2)
To recall the preset memory on the current band, press one of the preset buttons [1-6] .
6.
STEREO/MONO BUTTON
Press the ST button on the remote controller to select the STEREO or MONO sound mode
for FM band.
7.
LOC BUTTON
1) In RADIO mode, when the signal of the distance radio station are very weak and the
receiving effect is bad during tuning, check whether there is the word LOC on LCD. If there is
the word LOC on LCD, press this button to turn off the LOC function, then tune again for the
distance radio station;
2) In RADIO mode, when the signal of the local radio station are too strong to lead that the
interference to the receiving effect during tuning, press this button to turn on the LOC function
to display the word LOC on LCD, then tune again for the local radio station.
4.
Disc, USB and CARD Operation
4.1
Load/unload disc, USB or CARD
To play files in a disc or card, press the EJECT button to slide down the monitor .
Then insert the disc or card into the disc slot or SD/MMC Card slot.
To unload the disc or card, press the STOP button twice to stop playback, then press the
EJECT button to slide down the monitor and eject disc in the disc slot and then remove the
disc; or push the card firstly and pull it out of the card slot.
PDF created with FinePrint pdfFactory trial version
http://www.pdffactory.com
