Lantronix
SM4T4DPA Install Guide
33867 Rev. A
Page
15
of
29
Installing an Optional SFP Transceiver
You can install or remove a mini-GBIC SFP from a mini-GBIC slot without having to power off the switch.
Note
:
□
The SFP ports operate only at full duplex. Half duplex operation is not supported.
□
Ensure the network cable is NOT connected when you install or remove an SFP.
Inserting an SFP Transceiver into a Slot
To Install a SFP transceiver, do the following
:
Step 1. Consider network and cabling requirements to select an appropriate SFP transceiver type.
Step 2. Insert the transceiver with the optical connector facing outward and the slot connector facing down. Note
that SFP transceivers are keyed so they can only be installed in one orientation.
Step 3. Slide the SFP transceiver into the slot until it clicks into place.
Note
: SFP transceivers are not provided in the switch package.
Connecting to a Power Source
You can plug or remove the power cord from AC power socket to switch the power on and off.
Inserting the Power Cord to AC Power Socket
Step 1. Insert the power cable plug directly into the AC Socket located at the back of the switch.
Step 2. Plug the other end of the cable into a grounded, 3-Pin, AC power source.
Step 3. Check the front-panel LEDs as the device is powered on to be sure the POWER LED is lit. If not, check that
the power cable is correctly plugged in.
Warning
: For International use, you may need to change the AC line cord. You must use a line cord set that has
been approved for the socket type in your country.