Lantronix SISGM1040-284-LRT, Install Manual, Page: 37 / 45

Lantronix SISGM1040-284-LRT Install Guide
33808 Rev. E https://www.lantronix.com/ 37
Connect and Log In via the CONSOLE Port
Access to the Switch is protected by a logon security system. You can log on to the switch with the user name and
password. After a failed logon attempt, the system displays Wrong username or password!.
After you log on, the system monitors the interface for periods of inactivity. If the interface is inactive for too
long, you are automatically logged off.
The CLI initial user name and password is
admin
. You should change the password as soon as possible, because
the initial password is known to anyone who reads this manual. You can also change the user name or add
additional user names.
Console : Baud rate: 115200bps,
Data bit: 8,
Parity: None,
Stop bit: 1
Flow control: none
Telnet Port
23
SSH Port 22 (In Windows, you can run a terminal emulator such as PuTTY)
CLI Initialization and Configuration (Optional)
1. Connect a PC to the SISGM1040-284-LRT Ethernet port (RJ45 Ethernet port).
2. In Telnet, enter the command telnet 192.168.1.77 .
3. Login with default account and password (Username: admin / Password: admin).
4. Change the IP address with the CLI commands below:
#
enable
#
configure terminal
(config)# interface vlan 1
(config‐if‐vlan)#
ip address 172.16.100.123 255.255.255.0
(config‐if‐vlan)#
exit
#
See the CLI Reference for more information.
Connect and Log In via a Web Browser
After initial power up, perform the initial switch configuration using a web browser. To begin the initial
configuration stage, reconfigure your PC’s IP address and subnet mask so the PC can communicate with the
switch. After changing PC’s IP address, you can access the switch’s Web GUI using the switch’s default IP address
of 192.168.1.77. The default Subnet Mask is 255.255.255.0. The default Username and Password are admin .
See the Web User Guide for more information.