Lantronix MSS1-T, Reference Manual

Page: 85 / 117

Commands Change Stopbits
6 - 25
None
Clears any previously configured startupfile name, host, and retry setting.
Retry
Instructs the MSS to re-attempt load of the startupfile a certain number of
times before giving up.
num
Specify the desired number or retry attempts. If zero is specified, the
server will retry until the startupfile is read (indefinitely).
Defaults Retrynum: 5
Examples
Local> CHANGE STARTUP FILE “bob:start”
Local> CHANGE STARTUP FILE hevax::start.com
Local> CHANGE STARTUP FILE “engfs\sys:\login\start.cmd”
Local> CHANGE STARTUP FILE RETRY 6
See Also Change Loadhost, page 6-13; Reloading MSS Software, page E-2.
6.56 Change Stopbits
Specifies how many stop bits the port will use.
Restrictions Requires privileged user status.
Default 1
See Also Change Autobaud, page 6-3; Change Charsize, page 6-6; Change Parity,
page 6-18.
6.57 Change Subnet Mask
Sets an IP subnet mask for the MSS. The mask is applied to target IP addresses to determine
whether the destination address is on the local network segment. If the address is not on the local
segment, the server’s gateway host will be accessed to provide the connection.
A mask is created by default when the IP address is set, but can be overridden with this command.
Restrictions Requires privileged user status.
Parameters mask
Specify a mask in numeric IP format, for example, 255.255.255.0.
See Also Change IPaddress, page 6-12; Change Gateway, page 6-10; Subnet Mask,
page 4-2.
CHANGE STOPBITS
1
2
 
 
 
CHANGE SUBNET MASK mask