Lantronix MSS1-T, Reference Manual

Page: 72 / 117

Change IPaddress Commands
6 - 12
6.21 Change IPaddress
Sets the MSS’s IP address. The IP address must be set before any TCP/IP functionality is available.
If there are any active TCP logins or sessions, the new IP address will take effect when the MSS is
rebooted.
Restrictions Requires privileged user status.
Parameters IPaddress
Specify the IP address in standard numeric format.
6.22 Change IPsecurity
Adds or edits entries in the IP Security table.
Restrictions Requires privileged user status.
Parameters IPaddress
Specify an address in standard numeric format. An address with 0 or 255
in any segment restricts all addresses in that range.
Default Disabled
Examples
Change IPsecurity 192.0.220.77 Disabled
Restricts the single IP address from the table.
Change IPsecurity 192.0.1.255 Disabled
Restricts all addresses between 192.0.1.0 and 192.0.1.255.
See Also IP Security, page 4-3.
6.23 Change LAT CircTimer
Specifies the delay between messages sent from the server to other network nodes. This parameter
should not need to be altered, and should not be altered when there are active sessions.
Restrictions Requires privileged user status.
Parameters timerValue
Specify a value from 30 to 200 milliseconds.
Default 80 (milliseconds)
CHANGE IPADDRESS IPaddress
CHANGE IPSECURITY IPaddress
DISABLED
ENABLED
 
 
 
CHANGE LAT CIRCTIMER timerValue