Lantronix MSS1-T, Reference Manual

Page: 83 / 117

Commands Change Silentboot
6 - 23
6.51 Change Silentboot
Causes the unit to attempt to boot without sending any status messages to the console port (unless
there are errors).
Restrictions
Requires privileged user status.
Default
Disabled
See Also
Show Server, page 6-33.
6.52 Change SNMPSetComm
Creates an SNMP community name for the MSS and gives that community read/write access.
Restrictions Requires privileged user status.
Parameters communityname
Enter an alphanumeric string of up to 15 bytes.
See Also TCP/IP, page 1-4.
6.53 Change Software
Specifies the name of the download file the MSS will attempt to load at boot time when a reload
has been requested. For IP loadhosts, this is the file that will be requested at boot time.
Restrictions Requires privileged user status.
Parameters filename
Specify the name of the loadfile, 11 characters or less. A .SYS extension
will be added. The complete pathname can also be entered if the file is to
be loaded via TFTP. The filename must be placed in quotes to preserve
case.
See Also Change Loadhost, page 6-13.
CHANGE SILENTBOOT
DISABLED
ENABLED
 
 
 
CHANGE SNMPSETCOMM communityname
CHANGE SOFTWARE filename