Lantronix LS Series, User Manual, Page: 14 / 26

Lantronix LSS2200-8P MobileApp User Guide
33870 Rev. A https://www.lantronix.com/ 14
Read NFC Tag
is used to check the configuration that has already been transferred to the switch.
Select READ NFC TAG, then hold the smartphone or tablet so the NFC reader is positioned directly over the
NFC tag on the switch that you want to check. When successfully read, you will hear a chime and the
configuration information will be displayed on the NFC READ NFC TAG Results page as shown below.
If the NFC tag was detected but not read, the information below is displayed.
Read NFC Tag start screen Read NFC Tag success Read NFC Tag Error
Scanning for tags Detected tag Detected tag – Error reading data on
tag. Please try again.
Parameter descriptions :
Detected Tag : Indicates the tag was detected. The next box displays the information from the device.
ip : Displays the detected IP address.
sysname : Displays the detected system name.
syscontact : Displays the detected system contact.
location : Displays the detected system location.
username : Displays the detected user name.
password
: Displays the detected system password.
serial : Displays the device serial number.
mac : Displays the device MAC address.
filename : Displays the name of the file.
subnetmask
: Displays the detected subnet_mask.
gateway : Displays the detected gateway IP address.
ipMode : Displays the detected IP mode (e.g., 0 = Static or 1 = DHCP).
nfc : Displays detected NFC setting (always 2 = Disabled). Always set to disabled when applying a config via
NFC.
ble : Displays the detected BLE setting (1 = Disabled or 2 = Enabled).