Lantronix EMG 7500, User Manual

Page: 233 / 482

11: Remote Power Managers
EMG™ Edge Management Gateway User Guide 233
Figure 11-2 RPM Shutdown Order
Notifications Displays the notifications configured for each PDU and UPS. See
Figure 11-3 .
Raw Data Displays a window with all of the information returned by the driver
when a query for status is requested. This option is available for all
RPMs. See
Figure 11-4
.
Logs Displays a window with any logging information that has been
accumulated for the selected RPM, if logging is enabled for the RPM.
This option is available for all RPMs. See Figure 11-5 .
Environmental Displays a window with any environmental (humidity and
temperature) information that may be available for the selected RPM,
if sensors are installed for the RPM. This option is available for all
RPMs. See
Figure 11-6
.
Managed Device Displays the RPMs - Manage Device page, with the complete status
and configuration for the selected RPM. This option is available for all
RPMs.
Outlets Displays the
RPMs - Outlets
page for RPMs that support individual
outlet control and status.
Beeper: Enable, Mute,
Disable
If the RPM has a beeper than can be controlled, these options allow
the administrator to Enable , Mute , or Disable the beeper. If you try to
use Mute to silence a beeper and the beeper continues to sound, the
UPS most likely does not support mute, and the Disable option will be
the only way to silence the beeper.
Reboot Reboots the RPM immediately, which may interrupt the power
provided by the RPM while it is rebooting. Some PDUs and UPSes
have a default delay that they will wait before initiating a reboot; this
setting may be visible in the raw data (see above) as
"ups.delay.reboot".
Shutdown Shuts down the RPM immediately, which will interrupt the power
provided by the RPM. Some PDUs and UPSes have a default delay
that they will wait before initiating a shutdown; this setting may be
visible in the raw data (see above) as "ups.delay.shutdown".
Delete Deletes the selected RPM, after a confirmation.