Lantronix
x6310 ION POTS Media Converter User Guide
33818 Rev. A
Page
28
of
39
3. Click the
Save
button to save the updated information.
DMI Parameter
descriptions
:
Parameter
Associated MIB variable
Description
Interface Characteristics
DMI ID
ionDMIId(8)
Specifies the physical DMI device ID from the standard; for
example: SFP/SFP+/SFP28, SG, Optical pigtail, SFP, 300-
pin XBI , XENPAK, XFP, XFF, XFP-E, XPAK, X2, DWDM-
SFP/SFP+, QSFP, QSFP+, CXP, Copper Pigtail, RJ45
(Registered Jack), No separable connector, etc.
Connector
Type
ionDMIConnectorType(1)
The external optical or electrical cable connector provided
as the interface. For example: LC, SC, Dual BNC coax
connectors, DB9 for RS232 and RS485, RJ-11, unshielded
twisted pair, SC fiber, 1550nm 40km, SC fiber, 1 x 9,
125km Gigiabit, ST Single-Fiber 155Mbps, LC Multimode
Fiber, SFP cage, Single-Fiber Multimode, SC Multimode
(long haul), LC Singlemode (long haul), XFP slot, SFP+
slot, etc. See below.
Nominal Bit
Rate (Mbps)
ionDMIBitRate(2)
Bitrate in units of 100Mbps (for example: 10500, or 10.G
Gbps) (measured rate).
Fiber
Interface
Wavelength
(nm)
ionDMILaserWavelength(9)
The Nominal transmitter output wavelength at room
temperature (measured wavelength). The unit of measure
is nanometers (for example: 1550 nm or 850 nm).
Diagnostic Monitoring
Receive
Power (uW)
ionDMIRxPowerLevel(16)
Receive power (measured power measurement) on local
fiber measured in microwatts (for example: 11 µW).
Receive
Power (dBM)
ionDMIRxPowerLevel(16)
Receive power (measured signal strength) on local fiber
measured in dBM (decibels relative to one milliwatt) which
defines signal strength. For example: -19.586 dBM.
Receive
Power Alarm
ionDMIRxPowerAlarm(17)
Alarm status for receive power on local fiber:
Normal -1,
Not Supported - 2,
Low Warn - 3,
High Warn - 4,
Low Alarm - 6
High Alarm - 7
Rx Power
Intrusion
Threshold
(uW)
ionDMIRxPwrLvlPreset(18)
A preset level for Rx Power on the Fiber port. If the DMI
read value falls below the preset value, an intrusion is
detected, and a trap is generated (0-10). The message
displays:
ALARM: Receive power is below specified
threshold. Fiber trap intrusion may be in progress
.
Note
: C4110 port 2 DMI data is not shown if there is no
SFP in port 1. Without an SFP in port 1, the port 2 DMI will
display "
The DMI feature is not supported on the current
port.
”. When an SFP is inserted into port 1, the port 2 DMI
displays as expected. To recover, insert an SFP in Port 1
and click the
Refresh
button.
