31
5.8 Syslog
This page allows the user to decide whether to send the system event log, and select the
mode which the system event log will be sent to client only, server only, or both client and
server. What kind of event log will be issued to the client/server depends on the selection
on the
Event Configuration
tab. There are four types of event
—Device Cold Start,
Authentication Failure, X-Ring Topology Change, and Port Event
—available to be issued
as the event log.
Syslog Configuration
Syslog Configuration interface
Syslog Mode:
Select the system log mode
—
Client Only
,
Server Only
, or
Both
.
‘Client
Only
’ means the system event log will only be sent to this interface of the switch, but on
the other hand
‘Server Only’ means the system log will only be sent to the remote
system log server with its IP assigned. If the mode is set in
‘Both’, the system event log
will be sent to the remote server and this interface.
SysLog Server IP Address:
When the
‘Syslog Mode’ item is set as Server Only/Both,
the user has to assign the system log server IP address to which the log will be sent.
Make sure the selected mode is correct, and click
Apply
to have the setting take effect.
Summary of Contents for IPES-2204F
