www.lanpro.com
Active Products - Switches - LP-SGW2400
8
3.12 Filter
Sets the source IP filter per port to block unwanted access.
Figure 13
3.13 Rate Limit
The Rate Limit can prevent the saome customer to occupy a
huge bandwidth which may affect the normal network using.
An ISP or WISP application as well as a district broadband
network environment needs this kind of switch application
quite a lot.
Port:
24 Optional 10/100/1000Mbps port, choose the
relative port if needed.
Policer/Shaper Speed:
optional is as below: 128kbps, 256kbps, 384kbps, 512kbps,
640kbps, 768kbps, 836kbps, 896kbps, 1024Mbps, 1152kbps,
1280kbps, 1408kbps, 1536kbps, 1664kbps, 1792kbps,
1920kbps, 2048kbps, 2176kbps, 2304kbps, 2432kbps,
2560kbps, 2688kbps, 2816kbps, 2944kbps, 3072kbps,
3200kbps, 3328kbps, 3456kbps, 3584kbps, 3712kbps,
3840kbps, 3968 kbps.
Notice:
If the chosen speed is higher than the practical
speed, the status column will display the chosen No. , but
not the practical speed.
Figure 14
3.14 Storm Control
Storm Control:
Can Prevent the switch the transfer of
broadcasts, when the broadcast package arrives, the
switch sets frames according to the customer’s setting, the
exceeding package will be thrownautomatically, this will
ensure that the switch runs in an stable way, Broadcast
Control speed:
optional is 1kfps, 2fps, 4fps, 8fps, 16fps,
32fps, 64fps, 128fps, 256fps, 512fps, 1024fps, 2048fps,
4096fps, 8192fps, 16384fps, 32768fps.
Figure 15
Remarks:
1.-
Broadcast means sending the data package to all the
host of thenetwork.
2.-
Multicast means sending the data package to a Host
group of the network.
3.-
Uncase means sending the data package to a Host of
the network.
4.-
Unknown uncase means the destination MAC address
haven’t been confirmed.
5.-
Switch cannot control the broadcast package totally, can
only restrict the broadcast sent speed.
