Lanier LW110, Operating Instructions Manual

Page: 34 / 189

Copying
22
2
H
Just as the trailing edge of the original passes the table edge, press the
{{{{
RF
Select/Cut
}}}}
key.
Important
❒
To cancel copying, press the
{
Clear/Stop
}
key. The copier finishes the oper-
ation in progress, and delivers the copy and the original.
❒
To cancel on-going copying, for example, when you have inserted a wrong
blueprint, press the
{
RF Select/Cut
}
key. The machine interrupts the opera-
tion in progress, and delivers the copy and the original.
❒
If you make copy without pressing the
{
RF Select/Cut
}
key, copied paper
might come out with originial size + 310mm.
❒
When you repeat the copy job with this function even if you select different
sizes of the originals, this function helps you to make same size copy.
❒
Once you set the cut length and press the
{
RF Select/Cut
}
key to enter the
repeat copy cycle, do not press the key. Otherwise, the copy job will be in-
terrupted. If you want to repeat the copy job again, press the
{
Paper Feed
}
key. For details about job settings, see
D
.
Preset Cutting
This function cuts roll paper to a selected length. The paper is cut to this length
regardless of the original size.
Note
❒
The default Preset Cut length is as follows. Metric Version: 1189mm, 841mm,
594mm, 420mm, 297mm Inch Version: 48.0", 42.0", 36.0", 24.0", 18.0", 11.0". To
change of the Preset Cut length pattern, please contact your service represent-
ative.