Installing Stabilizer
1.
COLLECT THE FOLLOWING PARTS:
(1) Fuselage
(1) Stabilizer
(1) Bottom wing
(2) #4 x 3/4” screws
4.
Mount the bottom wing to the fuselage using
the two #4 x 3/4” bolts.
5.
Slide the stab into the fuselage and align the
center marks on both sides of the fuselage.
2.
Put a piece of masking tape along the trailing
edge of the stab and measure and make a
mark in the center of the stab.
3.
Make another mark on each side of the center
line 1/4” over. These two marks will line the
stab up in the center of the fuselage at the
rear.
A
A
6.
Measure out the wing on each side an equal
distance and make a mark. Measure from the
tip of the stab to the mark on the wing and
adjust stab until both sides are the same( A
equals A)