8
INSTALLATION CONT’D
IF SETTING THE UNIT ON A COUNTER:
Split the back into two pieces.
Remove the screws from the rear of the cheese-melter; screw the stainless steel
portion of the back to the cheese-melter with the off-set at the top.
Reinstall the two back halves together and replace the screws around the edge.
When installing on a counter the legs
must be
installed before using the unit, as
they will provide the required clearance for the bottom of the unit.
Place the unit in location, and level using leg adjustments.
Observe minimum clearances at all times.
4.1 Electrical Connection
Electrical service routing may be made through either of two 1 1/4 inch knockouts
provided. One may be found along the bottom edge of the back panel. The second
knockout is located on the bottom of the unit.
4.2 Cheese-melter Voltage
The model MM36C-3-CLS Cheese-melter is shipped from the factory wired for 220
volts.
4.3 Phasing
All cheese-melters are shipped from the factory set up for a
single phase
service.
4.4 Elements
Elements for all electric Cheese-melters are shipped, packaged separately, within the
shipping crate.
These should be inspected upon opening of the shipping carton. If an element is found
damaged or broken, notify the Freight Company immediately.
Installation of the elements is not a warrantable expense. The installer or a qualified
service company should complete installation. Damage to elements or equipment
resulting from incorrect or improper installation will be the responsibility of the
equipment owner or individual installing elements.
WARNING:
DUE TO THE HIGH HEAT EXPOSURE EXPERIENCED AT
CONNECTIONS, USE OF NON-CERAMIC WIRE NUTS IS NOT
RECOMMENDED. DAMAGE TO EQUIPMENT, OR INJURY TO
PERSONNEL MAY RESULT.
CHEESE-MELTER SPECIFICATIONS
NOMINAL AMPS PER LINE
SINGLE PHASE
MODEL
NUMBER
TOTAL
kW
240 VOLT
WEIGHT
MM36C-I-CLS
3.6 15
135
lbs.
