11
MAINTENANCE & CLEANING
8.1 Door Reversal
Remove the three Phillips screws located at the back of the oven securing the top to
the oven.
Remove the top of the oven.
Open door and remove 5/8 bolt in the lower right-hand corner of the opening.
Remove the 5/8-door pin in the upper left hand corner holding the door to the oven.
Lift door off of lower door pin and set to side.
Remove the lower left-hand door pin and re-install into the lower right-hand
corner.
Place door on lower door pin and re-install the upper 5/8-door pin into the top of
the oven securing door to oven.
Place 5/8 bolt into vacant hole at the lower left of oven.
Re-install top of oven.
Re-install the three Phillip screws at the back securing top to the oven.
8.2 Cleaning
WARNING:
KEEP WATER AND SOLUTIONS OUT OF CONTROLS.
NEVER SPRAY OR HOSE CONTROL CONSOLE,
ELECTRICAL CONNECTIONS, ETC.
CAUTION:
MOST CLEANERS ARE HARMFUL TO THE SKIN,
EYES, MUCOUS MEMBRANES AND CLOTHING.
PRECAUTIONS SHOULD BE TAKEN TO WEAR
RUBBER GLOVES, GOGGLES OR FACE SHIELD AND
PROTECTIVE CLOTHING. CAREFULLY READ THE
WARNING AND FOLLOW THE DIRECTIONS ON THE
LABEL OF THE CLEANER TO BE USED.
•
Always start with a cold oven.
•
The stainless interiors can easily be cleaned using most domestic or commercial
oven cleaners.
•
Always follow the cleaner manufacturer's instructions when using any cleaner.
•
Care should be taken to prevent caustic cleaning compounds from coming in
contact with the blower wheel.
•
The oven racks and rack slides may be cleaned by removing them from the oven
and soaking them in a solution of ammonia and water.
•
The stainless steel door liners and oven front should normally be cleaned with a
soap and water solution.
•
Discoloration or heat tint may be removed with any of the following cleaners:
Penny Brite, Copper Brite, Du-Bois Temp, or Past Nu-Steel.
•
Always apply these cleaners when the oven is cold and rub in the direction of the
metal's grain.
Summary of Contents for EQS-AP
Page 16: ...16 WIRING DIAGRAM ...
