3
2M-W487, Full Size Electric Convection Oven, Plantinum
GENERAL OPERATION & PROGRAMMING
Convection ovens constantly circulate air over and around the product. This strips away the thin layer of moisture
and cool air from around the product allowing heat to penetrate more quickly.
Cooking times can be shortened and cooking temperatures can be reduced.
To convert standard deck oven recipes, reduce the temperatrue 50° degrees and the time by 5%.
Make minor adjustments as necessary.
Always weigh your product. This will give you a more consistent size, color and quality.
Check the product near the end of the initial cooking.
Do not open the oven door during baking, as this will change the baking characteristics of the oven and make it
difficult to determine a final program.
If the product is overdone on the outside and underdone on the inside, reduce the baking temperature.
If the product is pulling away from the edge of the pan, the temperature is too high or the cooking time too long.
A convection oven is a mechanical piece of equipment. The same control settings will always give the same results.
If the results vary, problems may be because of changes in the product preparation.
ECOH-PT Control Panel
The control panel consists of the following items. Detailed
operational descriptions are given later this section.
Power Switch:
Turns the oven on and off
Function Keys:
Keys are active when a program option
is displayed on the display adjacent to that key.
Up & Down Buttons:
Allows you to scroll through the
programming selections.
Cancel
: When scrolling through menus this will allow you
to back up to the previous menu. In program mode this
will allow you to back up to the previous step.
Alpha Numeric Display:
Visual interface.
Typical Operation Sequence
Power Switch
AlphaNumeric
Display
Function Keys
Up & Down Button
Cancel Button
IL1476
ACTION
RESULT
Press the on switch.
Control panel comes on; display
says “
LANG, Run Oven,
Time Date Program”
.
Select
“Run Oven”
.
Display will show a list of product
to choose.
Select Product button next to
Icon desired.
Display says “
Preheating to
XXXF
”.
Beeper sounds briefly.
Display says “
Ready
”
Select Product to start.
Display shows possible product
selection for that temperature.
Select Product to start..
Display says, “
Select shelf
”
Press Product button next to
desired shelf.
Display will show icon chosen and
begin to count down.
Beeper sounds continuously.
Display shows “
DONE
”, press
button and remove product from
that shelf.
Oven is ready for another
product.