This gain control allows you to adjust the audio level of instruments connected to the Channel 1 Mic and Line In sockets.
The FX level control determines the amount of signal from this channel sent to the onboard DSP module and FX/Mon out
High/Treble frequencies can be boosted or cut by this control for this particular channel. Sources that fall in this range are
cymbals, soprano vocals and keys above top C on a keyboard.
Low/Bass frequencies can be boosted or cut by this control for this particular channel. Sources that fall in this range are bass
guitar, kick drums, deep vocals and keys below middle C on a keyboard.
The Mic input is designed for low impedance microphones (200-600ohms), it is a balanced XLR so will work equally well with
microphones that are balanced or unbalanced. Level controlled by
The Line In socket is designed for line level signals such as those obtained from keyboards, sound modules and sounds cards.
Level controlled by (Both mic and line in sockets may be used at the same time.)
The High Impedance input is designed to accept many different types of instrument, and is particularly suited for instruments
such as acoustic guitars with piezo pickup systems.
21
1
1
1
Page 6 /12
2
3
FRONT PANEL CONTROLS
Laney
OPERATING INSTRUCTIONS
7
4
8
9
The onboard digital effects have been custom designed by Laney to complement the AH200 with a choice of delays, flange,
Rotary, Octave Down, Chorus, Reverb and combinations of these. Select the chosen effect here and then control the overall
level with and each channels individual level with
Sets the overall master level for the onboard effects section.
Enables the onboard digital effects processor. To allow remote switching of the effects, this switch must be switched in.
This socket is for the connection of a Laney FS1 mono footswitch, to remotely switch the effects section on and off.
RCA Phono socket input for the connection of line level equipment like CD/MP3 Players etc. The level is controlled by
Adjusts the input level of equipment connected to the CD input sockets
RCA Phono socket output that is post EQ and pre master volume for the connection to an external recording device, PA
system etc.
This is the master Bass control and affects the main mixed signal (ie. all channels)
This is the master Middle control and affects the main mixed signal (ie. all channels)
This is the master Treble control and affects the main mixed signal (ie. all channels)
Controls the input level through the Aux in socket
The Aux in socket allows you connect an external device such as the output from an effects processor or sub mixer. The level
is controlled by
Controls the overall sound level from the amplifier and to the main out socket
The FX/mon out socket contains the main FX bus signal prior to being routed to the internal effects processor. You can use
this to route to an external FX processor/PA System/Monitors instead if you wish. The level is channel dependent.
The main out socket contains the final mixed signal post master volume and prior to routing to the internal amplifier. Use it
for driving external power amplifiers etc.
Indicates that power is on and the unit active.
(Always switch off and disconnect power cord when not in use)
9
2
13
12
19
18
22
10
Page 7 /12
11
12
13
Laney
OPERATING INSTRUCTIONS
5
5
6
14
15
16
17
18
19
2
3
4
1
6
7
23
19
21
22
18 16
17
20
9
13
11
10
14
8
15
12
20
21
22
23
Summary of Contents for AH200
Page 1: ...USER MANUAL AH200...
Page 3: ...Page 3 12...
