E2
Tool end hook
Clutch parts
Winch parts
Guide device
Power output device
Rope end hook
4.
Direction switch:
used for switching rope out/in (winding forward/reverse). The
downward arrow lights up for rope out and the upward arrow lights up for rope in. The
direction of the rope should always be the same as the direction indicated by the arrow.
5.
Clutch knob:
switching the state of the clutch mechanism by rotation, turning the arrow of
the knob to the unlocking sign indicate that the clutch mechanism is disconnected and the
winding is in free state.Turn the knob arrow to locking sign indicate that the clutch
mechanism is connected and can transmit power.
6.
Tool end hook:
Used to connect anchor point in horizontal traction and traction object in
vertical traction.
7.
Guide:
Used to keep the rope is orderly wound on the winding.
8.
Stopper:
Fixed on the rope, keep a safe distance from the end of the hook, and stop in
advance when the rope is rewound.
9.
Rope:
There are two kinds of wire rope/polyethylene rope. There is a warning sign of one
meter at the end of winding, which indicates that the rope must stop at this position and stop
continuing to pull out.
10.
Rope end hook:
To connect with the object in horizontal traction, and connected with
anchor point in vertical traction.
11.
Battery pack:
Power supply for motor, 2Ah and 4Ah for optional.
READY FOR OPERATION
To Charge the Battery for First Use
1. Connect the charger to standard 110 - 240 volt outlet; a red light should appear on the
charger. NOTE: Always connect charger to standard 110 - 240 volt outlet before connecting
battery.
2. Fully insert the charging plug into the battery card slot until you hear a click or see the
battery button toggle back to a flat position. (See Fig. 1 & Fig. 2)
3. Charge the battery until the light on the charger turns stable green.
（
Depending on the
battery capacity, the charging time usually takes 2 to 4 hours
）
4. Press the battery button, pull out the charging plug, remove the three-pronged plug from the
outlet, and then disconnect the battery from charger.
5. Press the battery capacity display button, check the battery capacity through LED light.
NOTE: Do not leave the battery on the charger after the charge is completed. Unplug the
charger from the outlet, and then remove the battery.
