INSTALLATION PROCEDURE FOR PATH LIGHT:
1. Prepare footing as required by local codes, see Fig. 1, Fig. 2 and Fig. 3 for recommendations.
2. Set wooden anchor template in position over conduit. “FRONT” on the template indicates the front of
the unit, locating the luminaire side of the single performance bollard and the wayfinding bollards.
“FRONT” locates the small footcover side of the double performance bollard.
3. Mark anchor hole locations and remove the template.
4. Drill holes according to anchor size and depth, see Fig. 6. Clear holes of debris.
5. Attach anchors to base plate template as shown in Fig. 5.
6. Test fit template assembly with anchors into position before installing epoxy. Make any adjustments
as necessary to allow concrete anchors to freely install. Concrete anchor should sit centered in hole
and not rest against the side of the drilled hole.
7. Add epoxy to anchor holes per epoxy manufacturer’s recommendations.
8. Slowly set template assembly with anchors into position. Wipe away any excess epoxy before it cures.
9. Allow epoxy to fully cure. Remove hex bolts and washers. Remove wooden template.
10. For lighted bollards, remove driver housing cover. Remove bottom two bolts, then lift straight up to
disengage interior bolts. See Fig. 7.
11. Set bollard in position. Place footcover bracket in position, see Fig. 6 and Fig. 8. Install washers and
hex bolts. Tighten securely.
12. Install footcover castings, see Fig. 8. Use 5/64 hex key to back out set screw that is preinstalled in
footcover casting until end of set screw is flush with casting. Align casting with hole in footcover
bracket and thread set screw in to engage.
13. For lighted bollards, run line-in voltage up through empty zip tie on driver plate before making wiring
connections to terminal block, see Fig. 9. Tighten zip tie.
14. Reinstall driver housing cover.
Landscape Forms is not responsible for site preparation and footings. Footing recommendations are included in these instructions.
Installation Guide
www.landscapeforms.com Ph: 800.521.2546
Page 2 of 3
Fig. 6 – Anchor detail
HEX BOLT
5/16
WASHER
CONCRETE
ANCHOR
BASE
PLATE
FOOTCOVER
BRACKET
Profile
unlit perimeter bollard, wayfinding bollard, performance bollard
Date: May 20, 2022
Fig. 5 – Assembly template and anchors
5/16” HEX
BOLT
5/16”
WASHER
TEMPLATE
CONCRETE
ANCHOR
CONDUIT
OPENING
FRONT
(LUMINAIRE)
SIDE OF
TEMPLATE
Fig. 8 – install footcover
FOOT
COVER
FOOTCOVER
BRACKET
Fig. 7 – covers
FOOT
COVER
DRIVER
HOUSING
COVER
